Xantech MX88AI, MX88VI Mrip Installer Utility IP Setup, Using the WEB-BASED User Interface

Page 5

Figure 4: MRIP Installer Utility – IP Setup

In the IP field, enter in the desired static IP Address. If you do not know a good static IP Address, please consult ‘HOW TO PICK A STATIC IP ADDRESS’ on Page 3 of this instruction guide.

In the Network Mask field, enter in the value: 255.255.255.0

Leave the other two fields at 0.0.0.0.

Click on the “Set” button and the new static IP Address is ready to be used.

USING THE WEB-BASED USER INTERFACE

Now that you have set up a static IP address for your MRIP, you are ready to use it!

Once you have configured the MRIP with a static IP Address, you can use the Safari web browser on your iPad, or just about any web browser on other computers, to access the web page to control your MX88 (or MRC88m).

To do this, enter the IP Address of the MRIP in your web browser, just like would a web address.

On the iPad using Safari, once you have accessed the MRIP’s main page, you will want to add a shortcut to this page on your Home Screen. To do this, do the following steps:

1.Tap on the “+” button at the bottom of the screen.

2.Tap the “Add to Home Screen” button.

3.Give the shortcut a meaningful name.

4.Tap on the “Add” in the upper right corner of the display.

5.Now you have an icon on your home screen that gives you direct access to control your system!

6.Using this shortcut icon will also show you the control page in full-screen mode, without any interference from Safari.

-5 -

Image 5
Contents Introduction Installation InstructionsCommon network system for the MX88vi/MX88ai ConnectionsHOW to Pick a Static IP Address Network Configuration OverviewHow to start the Mrip Installer application Setting UP a Static IP AddressUsing the WEB-BASED User Interface Mrip Installer Utility IP SetupUpdating the Mrip Firmware