IR Codes

In the event of IR conflicts, please do the following:

1.Remove the battery cover from the back of the RMT16-IR remote.

2.Locate the Dip Switches above the batteries

3.Switch the Dip Switches on the RMT16-IR to any of the combinations pictured below.

4.Dip Switches 1 and 2 in the RMT16-IR correspond with Dip Switches 3 and 4 inside the 4x4 HDMI Matrix respectively. Switch the switches inside the 4x4 HDMI Matrix to match the same Remote Channel as the RMT16-IR. The 4x4 Matrix is now set to a new IR Code.

- 5 -