Encore electronic manual ENUTV-DVB-S User’s Guide

Page 12

ENUTV-DVB-S User’s Guide -

There are many different satellites, load a default satellite in the transponder list. Click [Load] button under the satellite item. The following picture will display on the screen. Or, you can choose the satellite you need.

a) [Name]

Press to display the drop-down list, and select the desired satellite from the list. Input the satellite name you want to add.

b) [DiSEqC]

The item is used to select the DiSEqC port. This is compatible with the DiSEqC 1.0 protocol. c) [Dual Oscillator]

The Low Noise Block (LNB) is a combination of a low noise amplifier (LNA) and down converter which built them into one device. As one LNB has limited bandwidth, so we need two LNBs, low and high LNB. Select C band, Single or Double according to the type of dish you have. If you have select C Band, the frequency values of low LNB is 5150. If you have single LNB mode, the frequency values of low LNB is 11300. If you have dual LNB mode, to change the default value, click in the [Low LNB] and [High LNB], select needed frequencies from them. In this case, [22K] is inactive.

d) [ToneBurst]

Select [OFF] or [ON] in this column.

12

Image 12
Contents ENUTV-DVB-S User’s Notice Contents Package Contents IntroductionSystem Requirements ENUTV-DVB-S Hardware Installation Getting StartedDevice Driver Installation Install the DirectX Install the ENUTV-DVB-S Application We recommend you not to change the default location Launch the ENUTV-DVB-S Program LNB Setting Load SatelliteENUTV-DVB-S User’s Guide Add Satellite Modify SatelliteDiSEqC Setting Delete SatelliteChannel Scanning Transponder Parameters IP Receiver ENUTV-DVB-S User’s Guide Application Programs CaptureRecord Scheduler System Setting EPGFunction buttons overview Using the Remote Control Trouble Shooting Hardware trouble shootingSoftware trouble shooting Technical Support2008/06/30 Version