③. Enter '5' to change the current disk drive and press 'ENTER'.
④. Select the drive you want to install and format, in this example disk '2' but note that this may vary from your setup!
⌕If you can not see the external hard drive at this point, please check your jumper settings, cable connection, power supply and if required, the driver installation.
⌕For 2.5" Hard Drive, you can also connect the drive directly to your internal IDE bus if you
encounter problems with the external drive and install it later formatting.
⑤. Choose '1' to create a primary DOS partition and follow the on screen instructions. After you have created the partition according to your requirement, close the
- 17 -