A13 |
Pull wires through the strain relief.
A14 | Ground |
|
| Green |
|
| A |
|
| Bare Copper | |
A |
| A |
| Black | White |
Connect wires as shown.
A19 |
H |
Reinstall the motor by inserting the tabs and pushing up
into position. Make sure the wires are not pinched
between the motor and the housing.
A20 |
I |
Secure the motor by tightening the 2 screws.
A15 | F |
| |
| 2 |
| 1 |
| F |
Install the wiring cover plate. Make sure all wiring connections are inside the box or under the wiring cover plate.
A16 |
G |
Tighten the wiring cover plate screw.
A21 |
Turn on the power source.
A22
ON
OFF
Test the motor. If the motor does not run, check the plug
connection.
A23
Go to step
E1
Connect 4” duct and vent to the outside. Tape joints. If ducting does not fit securely, an adapter may need to be purchased.
6
Connect wiring from the motor to the wiring cover plate.
on page 17 to attach grille.
7 |