DTH600_US 8/8/02 10:21 AM Page 5
Initial setup ...
Fitting the battery beneath your player
The
the player’s 3 holes and 2 slots respectively.
Install the battery beneath the player using the locating pegs and retaining brackets intended for this purpose:
1.Lay the battery down flat as shown in the illustration.
2.Place the player on top of the battery so that the battery’s locating pegs fit into the fixing holes
( 
) on the underside of the player.
3.Slide the player backwards on the battery until it clicks into place.
3
1 2
Locating pegs
Retaining brackets
Initial setup of your remote control
3
2
1
Fit the CR 2025 battery into the remote control unit as indicated.
4 |
In order to avoid any risk of explosion, observe polarities indicated inside the battery compartment. Replace only with the type of batteries specified above. Do not throw them into fire, do not recharge them. If you are not using the remote control unit for an extended period (several weeks), take the battery out.
5