Sony DVP-NC80V Setting the digital output signal, Audio Filter, Digital OUT, Dts

◆AUDIO FILTER

Selects the digital filter to reduce noise above

22.05kHz (Sampling frequency (Fs) of the audio source is 44.1 kHz), 24 kHz (Fs is

48 kHz), or 48 kHz (Fs is above 96 kHz).

SHARP	Provides a wide frequency range
	and spatial feeling.
SLOW	Provides smooth and warm
	sound.

Note

There may be little effect by changing the digital filter depending on the disc or playback environment.

◆DOWNMIX (DVD VIDEO/DVD-VR mode only)

Switches the method for mixing down to 2 channels when you play a DVD which has rear sound elements (channels) or is recorded in Dolby Digital format. For details on the rear signal components, see “Checking the audio signal format” (page 45). This function affects the output of the following jacks:

– LINE OUT L/R (AUDIO) jacks

– DIGITAL OUT (OPTICAL or COAXIAL) jack when “DOLBY DIGITAL” and “DTS” is set to “D-PCM” (page 70).

DOLBY	Normally, select this position.
SUR-	Multi-channel audio signals are
ROUND	output to 2 channels for enjoying
	surround sounds.
NORMAL	Multi-channel audio signals are
	downmixed to 2 channels for use
	with your stereo.

◆DIGITAL OUT

Selects if audio signals are output via the DIGITAL OUT (OPTICAL or COAXIAL) jack.

ON	Normally select this position. When
	you select “ON,” see “Setting the
	digital output signal” for further
	settings.
OFF	The influence of the digital circuit
	upon the analog circuit is minimal.

Note

Super Audio CD audio signals are not output from a digital jack.

Setting the digital output signal

Switches the method of outputting audio signals when you connect a component such as an amplifier (receiver) or MD deck with a digital input jack.

For connection details, see page 20. Select “DOLBY DIGITAL,” “DTS,” and “48kHz/96kHz PCM” after setting “DIGITAL OUT” to “ON.”

If you connect a component that is incompatible with the selected audio signal, a loud noise (or no sound) may be heard from the speakers, risking damage to your ears or speakers.

◆DOLBY DIGITAL (DVD VIDEO/DVD-VR mode only)

Selects the type of Dolby Digital signal.

D-PCM	Select this when the player is
	connected to an audio
	component without a built-in
	Dolby Digital decoder. You can
	select whether the signals
	conform to Dolby Surround
	(Pro Logic) or not by making
	adjustments to the
	“DOWNMIX” item in
	“AUDIO SETUP” (page 70).
DOLBY	Select this when the player is
DIGITAL	connected to an audio
	component with a built-in
	Dolby Digital decoder.

◆DTS

Selects the type of DTS signals.

D-PCM	Select this when the player is
	connected to an audio
	component without a built-in
	DTS decoder.
DTS	Select this when the player is
	connected to an audio
	component with a built-in DTS
	decoder.

70