Yamaha 127, DVD-S1700, DVD Player manual Troubleshooting, 37 En, Problem Solution See

TROUBLESHOOTING

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized YAMAHA dealer or service center.

Problem			Solution	See
				page
No power	Connect the AC power cable properly.			12
	Press STANDBY/ON on the front panel of this unit to turn on the			13
	power.
No picture	Refer to the manual supplied with your TV for correct Video In			–
	channel selection. Change the TV channel until you see the DVD
	screen.
	Turn on your TV.			–
	If [Progressive Scan] is set to [On], check that you have connected			32
	this unit to a progressive scan TV through the component video jacks.
	Otherwise, follow the steps below to turn off the progressive scan;
	1.	Press	on the front panel to open the disc tray.
	2.	Press CLEAR on the remote control.
	3.	Press “2580” using the numeric buttons (0-9) on the remote
		control.
	4.	Press AUDIO on the remote control.
	If [HDMI Video] is set to other than [Auto], check that the resolution			33
	is supported by the HDMI-compatible monitor you have connected.
	Otherwise, follow the steps below to change the setting to [Auto];
	1.	Press stwice on the front panel or STOP ( 7 ) twice on the
		remote control to stop playback.
	2.	Press and hold sand p/eon the front panel at the same time for
		three seconds.
	If the HDMI indicator flashes orange, check that you have connected			12
	this unit to an HDCP-compatible component.
	Check that the video signal output setting matches the video			33
	connection.
Completely distorted picture or	Check that the disc is compatible with this unit.			3
black/white picture
	Check that the TV type of this unit is set to match that of the disc and			14
	your TV. If you set the TV type improperly, follow the steps below to
	return to the default setting;
	1.	Press	on the front panel to open the disc tray.
	2.	Press CLEAR on the remote control.
	3.	Press “2580” using the numeric buttons (0-9) on the remote
		control.
	4.	Press AUDIO on the remote control.
	Check the video connection.			11
The screen size looks unnatural,	Check that the TV setting of this unit matches the screen size of your			31
or the caption is displayed only	TV.
partially on the TV monitor or is
	Change the screen size and the aspect ratio of your TV.			–
not displayed at all

English

37 En