Symphonic SC1304 owner manual Channel SET UP, Auto Channel Programming, ADDING/DELETING Channels

CHANNEL SET UP

2Select “ADD / DELETE CH”

Make sure ...

Use [PLAY/K] or [STOP/L] to

– CHANNEL SET UP –

AUTO CHANNEL PROGRAMMING

As the initial setting, this unit has memorized all channels, including the ones not available in your area. This feature automatically puts only available channels into the memory.

1 Select “CHANNEL SET UP”

Press [MENU].	– M E N U –
	TIMER PROGRAMMING
Use [PLAY/K] or [STOP/L] to	PICTURE CONTROL
	SETTING CLOCK
point to “CHANNEL SET UP”,	B CHANNEL SET UP
	V-CHIP SET UP
	USER’S SET UP
then press [F.FWD/ B].	LANGUAGE [ENGLISH]
	CAPTION [OFF]
	ZERO RETURN
	TIME SEARCH
2 Begin channel scanning	– CHANNEL SET UP –
Use [PLAY/K] or [STOP/L] to
point to “AUTO CH PROGRAM-	ADD / DELETE CH (CATV)
	B AUTO CH PROGRAMMING
MING”, then press [F.FWD/ B].
The tuner scans and memorizes all
the active channels in your area.

3After scanning

The tuner stops on the lowest memorized channel.

NOTES:

•If there is no TV signal input, “NO TV SIGNALS” will appear on the display after the completion of channel scanning.

•The unit may recognize TV channels to be CATV channels if reception condition is poor. In this case, check the antenna connection and try “AUTO CH PROGRAMMING” again when reception condi- tions are better.

•Auto channel programming is NOT necessary when connected to a cable box or satellite box. Just select the channel for the cable box or satel- lite input (ex. CH3 or CH4) on the unit, then select your desired channel on the cable box or satellite box.

ADDING/DELETING CHANNELS

The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.)

1Select “CHANNEL SET UP”

Press [MENU].	– M E N U –
	TIMER PROGRAMMING
Use [PLAY/K] or [STOP/L] to	PICTURE CONTROL
	SETTING CLOCK
point to “CHANNEL SET UP”,	B CHANNEL SET UP
	V-CHIP SET UP
	USER’S SET UP
then press [F.FWD/ B].	LANGUAGE [ENGLISH]
	CAPTION [OFF]
	ZERO RETURN
	TIME SEARCH

point to “ADD / DELETE CH”, B ADD / DELETE CH (CATV)

AUTO CH PROGRAMMING

then press [F.FWD/ B].

3Enter the desired channel number

Use [PLAY/K] or [STOP/L] or the Number buttons until your

desired channel number appears.	08
(You can also use	ADD / DELETE
[CHANNEL K/L] to enter it.)

•You must precede single-digit

channel numbers with a zero (Example: 02 ... 09).

•When selecting cable channels which are higher than 99, press [+100] first, then enter the last two digits. (Example: to select channel 125, first press [+100] then press [2] and [5].)

4Delete (or add) it from (or into) memory

Use [REW/s] or [F.FWD/B] then the channel number turned to red. The channel is deleted from memory. If the channel number turned to blue, the channel is added into memory.

•To delete another channel, repeat steps 3 to 4.

•If you use [REW/s] or [F.FWD/ B] again, the channel is memorized again.

Added channel : Light blue

Deleted channel : Light red

5Exit the channel setup mode

Press [MENU] to returns to TV mode.

NOTE:

•To confirm that channel(s) has been deleted or added, use [CHANNEL K/L].

- 11 - EN