Emerson EWC1302, EWC1902 Precautions, Location, Avoid the Hazards Electrical Shock and Fire

Page 4

PRECAUTIONS

LOCATION

For safe operation and satisfactory performance of your TV/VCR, keep the following in mind when selecting a place for its installation:

Shield it from direct sunlight and keep it away from sources of intense heat.

Avoid dusty or humid places.

Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the unit. Do not place the unit on a carpet because this will block the ventila- tion holes.

Install unit in a horizontal position.

Avoid locations subject to strong vibration.

Do not place the TV/VCR near strong magnetic fields.

Avoid moving TV/VCR to locations where temper- ature differences are extreme.

AVOID THE HAZARDS OF

ELECTRICAL SHOCK AND FIRE

Do not handle the power cord with wet hands.

Do not pull on the power cord when disconnecting it from an AC wall outlet. Grasp it by the plug.

If, by accident, water is spilled on your unit, unplug the power cord immediately and take the unit to our Authorized Service Center for servicing.

Do not put your fingers or objects into the TV/VCR cassette holder.

Do not place anything directly on top of the unit.

WARNING

Moisture condensation may occur inside the unit when it is moved from a cold place to a warm place, or after heating a cold room or under conditions of high humidity. If a tape is played in a TV/VCR which has moisture, it may damage the tape and TV/VCR. Therefore when the condensation occurs inside the unit, turn the POWER button on and allow at least 2 hours for the unit to dry out.

IMPORTANT COPYRIGHT INFORMATION

Unauthorized recording or use of broadcast televi- sion programming, video tape, film or other copy- righted material may violate applicable copyright laws. We assume no responsibility for the unautho- rized duplication, use, or other acts which infringe upon the rights of copyright owners.

FCC WARNING- This equipment may gener- ate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction man- ual. The user could lose the authority to oper- ate this equipment if an unauthorized change or modification is made.

This equipment has been tested and found to com- ply with the limits for a Class B digital device, pur- suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be deter- mined by turning the equipment off and on, the user is encouraged to try to correct the interfer- ence by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a cir- cuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

The serial number of this product may be found on the back of the unit. No other TV/VCR has the same serial number as yours. You should record the number and other vital information here and retain this book as a per- manent record of your purchase to aid identification in case of theft. Serial numbers are not kept on file.

Date of Purchase

Dealer Purchase from

Dealer Address

Dealer Phone No.

Model No.

Serial No.

- 4 -

EN

9I03

Image 4
Contents OWNER’S Manual Important Safeguards S2 8 9 8 a Precautions LocationAvoid the Hazards Electrical Shock and Fire Important Copyright InformationTable of Contents IndiceFeatures Supplied AccessoriesOperating Controls and Functions 9101112Rear View Preparation for USE ANTENNA/CABLE ConnectionsSET UP for USE External Input ModeInstalling the Batteries Channel SET UP for First TimeClock SET UP Auto / Manual Auto Clock SettingManual Clock Setting To Select a Desired ChannelChannel SET UP Again To Change Clock SettingDeleting or Adding Channel SETDAYLIGHT-SAVING Time To Cancel the DAYLIGHT-SAVING TimeSelecting the Language Game Mode TV OperationWatching a TV Program Picture ControlChip SET UP To Cancel the Closed Caption SystemWhen the Closed Caption Mode is on TV Rating SET UPWhen you select TV-Y7 Mpaa Rating SET UPSelection Rating Category Explanations Auto Repeat Playback PlaybackNormal Playback Search Still PicturePicture Search Zero ReturnRecording Picture ControlsNormal Recording Skipping Unwanted Scenes During RecordingPushes Display Recording length Timer RecordingChannel CH61 Tape Speed SP To Correct a Program Timer Program ExtensionTo set another program, repeat steps 2 to Wake UP Timer Hints for Automatic Timer RecordingAuto Return Sleep Timer To Cancel the Wake UP TimerTo Cancel the Sleep Timer Copying a Video TapeSpecial Features MaintenanceOn Screen Display Real Time Tape CounterTroubleshooting Guide Problem Corrective ActionClosed Caption Problem Possible Remedy TV/VCRSpecifications General SpecificationsElectrical Specifications Other SpecificationsControles DE Operación Y SUS Funciones Botón B Conexiones DE ANTENA/CABLE Preparación DE Canales POR Primera VEZ Tel Funai CorporationPlease do not Ship Your Unit to the Teterboro Address