Magnavox CCB255AT Adding/Deleting Channels, Repeat steps 3-4 to add or delete other channels

Page 11

Automatic Channel Setup (cont’d) 11

Adding/Deleting Channels

1

Press the COMBI button, then press the MENU button.

2,4

TO ADJUST PRESS { / B CH123

>	CHANNEL		SAVED
	FM ANTENNA
	SMARTLOCK
	REVIEW
	EXIT
	PRIM. SETUP

POWER

SLEEP/WAKE UP

SPEED

REC/OTR

PLAY

REW

STOP

EJECT

MEMORY

PAUSE/STILL

F.FWD

21

Press the PLAY/o button or the STOP/p button to select

CHANNEL.

TO ADJUST PRESS { / B

CH123

>	CHANNEL		SAVED
	FM ANTENNA
	SMARTLOCK
	REVIEW
	EXIT
	PRIM. SETUP

MENU	STATUS/EXIT		CLEAR

1	2	3
4	5	6	CH.
4	5	6
7	8	9
FM	0	SURF	VOL.
			VOL.
CABLE/DBS	COMBI
		VCR PLUS+
VAR.SLOW		/ENTER	MUTE

5

3

3

Press the CH(annel) m/n button to select the channel you want to add or delete.

TO ADJUST PRESS { / B

CH23

>	CHANNEL		SAVED
	FM ANTENNA
	SMARTLOCK
	REVIEW
	EXIT
	PRIM. SETUP

4

Press the F.FWD/B button or the REW(ind)/{ button to select SAVED (to add that channel) or DELETED (to delete that channel).

Repeat steps 3-4 to add or delete other channels.

5

Press the STATUS/EXIT button.

Programming of the last channel you selected will appear.

Helpful Hints

•Line Input mode will always be stored in the TV/VCR’s memory as channel 00. You cannot delete it.

•To review the channels memorized by the TV/VCR, follow these steps.

1)Press the COMBI button, then press the MENU button.

2)Press the PLAY/▲ button or the STOP/▼ button to select PRIM. SETUP. Press the F.FWD/B button.

3)Press the PLAY/▲ button or the STOP/▼ button to select CH MEM- ORY REVIEW. Press the F.FWD/B button. A list of programmed chan- nels will appear on the screen.

4)If all the programmed channels don’t fit on the screen, press the F.FWD/B button. If you do not press the F.FWD/B button within 10 seconds, the remaining channels will appear on the screen. (If there are no remaining channels, the pre- vious menu will appear.) Or press the REW(ind)/{ button to see the previous screen of channels.

5)Press the STATUS/EXIT button once or twice.

Image 11

Contents CCB255AT Model No Serial No Dear Philips product ownerFor Customer Use This bolt of lightning indi- cates uninsulated materialDeclaration of Conformity FeaturesSafety Precautions IntroductionTable of Contents Erasure Prevention Putting Batteries in the Remote ControlUsing the Remote Control TV/VCR MaintenanceRod Antenna Hook up your TV/VCR using one of the connections shownHooking Up the TV/VCR RF coaxial cable Not suppliedCrooked Pin Straight Pin Hooking Up the TV/VCR cont’dJacks on VCR Bent pinPress the Menu button. The screen shown below will appear Press the Combi button, then press the Power buttonTurning On the TV/VCR Press the Combi button, then press the Menu button Language SelectionWait for the TV/VCR to set up channels Automatic Channel SetupProgramming of the last channel you selected will appear Adding/Deleting ChannelsPress the PLAY/o button or the STOP/p button to select Repeat steps 3-4 to add or delete other channelsCable Box users must set the clock manually Setting the ClockManual Clock Setting Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’dNOW Searching flashes on the TV/VCR screen Wait for the TV/VCR to findTime Manual PBS Channel Selection Wait for the TV/VCR to find the time Use the Number buttons to select your PBS stationTime Daylight Savings Time Daylight-Savings TimePress the PLAY/ button or the STOP/ button to select PRIM. SETUP. Then, press the F.FWD/B buttonTime Zone Cable BOX Codes Setting the Remote to Operate a Cable Box/DBSSetting the Remote to Operate a Cable Box/DBS cont’d Front Panel Connect your antenna or cable here AC Power CordRear Panel ANTenna JackRemote Control Buttons REWind/ Button VOLume m/ n ButtonPAUSE/STILL Button Memory ButtonPress the REWind/ button or the F.FWD/B button to Adjusting the Picture ControlsAdjust the picture control. Refer to the chart on When you finish, press the STATUS/EXIT buttonDecreased brightness Decrease IncreaseIf you select Status OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status ON, then select Counter only onInsert a tape in the TV/VCR PlayingPress the RECord/OTR button once to start recording Power button to turn on the TV/VCR, if necessaryRecording OTR One-Touch RecordingDifferent brands of equipment may operate differently Rerecording Tape DuplicationFollow the steps below to prevent accidental recording Defeat RecordingDaily Timer RecordingLowed by the SET Clock menu Timer Recording cont’d FM 0 Surf VOL Timer Recording cont’dChecking or Clearing Timer Recordings Station Setting Up the VCR Plus+ Programming SystemTV Channels Setting Up the VCR Plus+ Programming System cont’d You have completed the steps on pages Timer Recording With the VCR Plus+ Programming SystemTimer Recording With the VCR Plus+ Programming System cont’d Appear on the screen Real-Time Counter MemoryRepeat Play ON-SCREEN Mode Defeat Recording OFFInsert a tape in the TV/VCR B Repeat PlayFlashing a will become a flashing B Repeat Play cont’dViewing a Still Picture Playback OptionsForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPBlue Background To block ratings, follow the steps below SmartLockExample Specific Sub-ratings SmartLock cont’dRatings are defined on After you enter the code, the Smartlock menu will appear To change the access code, follow these stepsTV-Y7 To check the SmartLock settings, follow these stepsPress the Combi button, then press the SLEEP/WAKE UP button Sleep TimerTimer during a recording Wake Up Timer Screen Closed CaptionExample MenuHalf-screen text Closed Caption cont’dStandard Closed Captions Smart Sound Volume Bar/Smart SoundVolume Bar Volume will stay at the same levelAutomatic Operation Features Press the CHannel m/n button until your desired radio SmartPicture/FM RadioSmartPicture FM RadioPress the Mute button, then press the PAUSE/STILL button If another remote control beepsPress the Combi button, then press the Menu button ReminderIndex Search Specifications Glossary Helpful Hints Helpful Hints cont’d Renewed Index Supplied Accessories