JVC TV 13140 operating instructions Manual Clock Setting, TV Operation

MANUAL CLOCK SETTING

You must set the date and time manually for timer recordings, ON/OFF Timer and Daylight Saving Time If the AUto Clock process did not _ them correctly,

EXAMPLE: Setting the clock to _8:30 AM',23th (SAT) October, 1999.

TV OPERATION

ill	tose,thosYsTE.
	SET option, then press the ENTER button,
	Press the SET + or - bulton to seleut the CLOCK
SET-Up option, then press the ENTER button.
SET<-	SET+

_ SET

SET-

i ST_VJ_ T_

-"(d_kTERMENU)

UTO tom on the TV/VCR, press the POWER button.

AdjustpressingtbethevoiomeVOLUMEleval +byor -	optionSet thetoTV/CA'rVthe appropriatemenu
button. The volume Level will	position. (See page 21 .)
be indicated on the screen by green
bar. AS the volume level increases,
so do the number of ber_ If the
volume decreases, the number of
green bar also decreases.
	[ CTVATV VHFL_I"FTvCChhaannnnt/I _s

1"/CAW

VHFVHF

2-132-13

UHF STD/HRC/IRC

14-69t4-36

(A) (W)

VHF/UHF/CATV CHANNELS 37-59

press the SET + or - budcn	Sat the day, year and time	After setting the clock, date an_ time"_
to set the month, then press	as in stop 3.	starts functioning automatically.
the ENTER button.
SET÷	SEt-+

NOTE: • After a power lallure or disconnection of the power plug, the time display will be lost. In this case, set the present grne again if the Auto Clock did not set correctly.

•If you want to conect the digits while setting, press the CANCEL button until the item you want to correct, then press the SET+ or - buttonto correct the desired setting.

	/(_'_'-.=J.,_	I	I (_'_(zzz)=_I
			95-99
			(A-S)(A-l)
			100-125
			(SA)
_	W mode direct channel indention -			/
	Press the Direct Channel selec0orlbuttonsto select the channel.
	When the W/CAW menu option is in the TV position,ell channels can be instantlyselected by using two
	buttons, (forexample, to select chan,lts2, pre_.s"0", then "2". If you press only "2",channelselection willbe delayed for/
	a few seconds.) For channels 10 and above, press the 2 digitsin order.	0	1	2

When the TV/CATV menu optionis in the CAW portion, channels P.anbe sts_t_d as to_iows:

TO SELECT CATV CHANNELS:

1-9 Press "0"twice, than 1-9 as needed. (Example, to select channel 2, press 002.)

10-12 Press "0",then the remaJning2 digits. (Example, toselect channel t 2, press 012,)

100-125 Press the 3 digits in orbed,(Example, to select channel 120, press 120.)

NOTE FOR CHANNELS 1-12:

If only 1 or 2 buttons are pressed, the corresponding channel will be selected in 2 seconds.

NOTE: • If a channel with no broadcast is selected, the sound will automatically be muted.

•If a station being viewed stops broadcasting, the "IV will automatically shut itself oft after 15 minutes.

16 17