Getting Started
English
Inserting Batteries
AOpen the battery compartment.
BInsert two batteries type R03 or AAA, following the indications (+ / - ) inside the compartment.
CClose the cover.
CAUTION:
Never throw batteries into a fire.
Note:
-Be sure to use AAA size batteries.
-Dispose of batteries in a designated disposal area.
-Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with applicable laws and regulations.
-If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with new ones.
-When necessary to replace batteries in the remote control, always replace both batteries with new ones. Never mix battery types or use new and used batteries in combination.
-Always remove batteries from remote control if they are dead or if the remote control is not to be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment.
Using the Remote Control to Operate the System
30 30
Within about 6m (19 feet)
1 2 3
4 5 6
AAim the Remote Control directly at the remote sensor (IR) on the front panel.
BDo not put any objects between the Remote Control and DVD Player while operating the DVD Player.
Finding your viewing channel
APress I/2ON/STANDBY on the DVD player to turn it on.
BTurn on the TV and set it to the correct
Usually these channels are between the lowest
and highest channels and may be called FRONT, A/V IN or VIDEO. See your TV' s manual for more details.
Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel.
Or, the TV remote control may have a button that chooses different video modes.
Or, set the TV to channel 3 or 4 if you are using an RF modulator.
CIf you are using external equipment, (such as audio system or receiver), turn it on and select the appropriate input source for the DVD player output. Refer to the equipment user’s manual for detail.
Setting up Progressive Scan feature
(For Progressive Scan TV only)
The progressive scan display twice the number of frames per seconds than interlaced scanning (ordinary normal TV system). With nearly double the number of lines, progressive scan offers higher picture resolution and quality.
Before you start...
ATurn on your TV and select the video input connected to the DVD player (refer to your TV user manual).
BPress I/2ON/STANDBY on the remote control to turn on the DVD player.
The blue DVD background screen will appear on the TV.
CPress SETUP.
DPress / to select { Video }, then press .
Language | Aspect Ratio | : 4:3 |
| View Mode | :Auto Fit |
Video | Video Out | Component |
| Smart Picture | |
Audio | JPEG Interval | : 5 Seconds |
Rating
Misc
EPress / to select { Video Out }, then press .
FSelect { P- Scan }, then press OK to confirm. The menu will appear on the TV.
Video Out
Activating Progressive Scan 1. Ensure your TV supports Progressive Mode
2.If there is a distorted picture on the TV, wait 15 seconds for automatic recover
Yes | No |
Helpful hint: Press to go back to previous menu item. Press SETUP to exit the menu item.
11