You will probably use your SPIRIT FOLIO 4 with a wide range of different types of sound source, and these will be at varying signal levels. It is important to set the GAIN of the inputs correctly to give the best performance.
Set up the individual mono input channels as follows:
∙Plug in the chosen source (usually the MIC input for mics and the LINE input for anything else). Plug in phantom powered mics before switching the phantom power on.
∙Set the Master and Group Faders fully down.
∙Provide the chosen source with a typical signal level and press and hold the PFL button by the fader. The level of signal will be shown on the
∙Adjust the input GAIN until the PPM meter is just reaching the amber LED (0dB) at a typical maximum source level with a steady signal. If the source signal is rich in
∙Adjust each mono input channel in the same way.
∙If you find that you cannot set a reasonable level within the range of the GAIN control when using a MIC input, try the LINE input instead.
The Stereo inputs do not have a GAIN control, since the typical source for these inputs will be external tape machines or effects units which have a much more predictable signal level. Set the
You will now have initial settings for each of the input sources and are ready to start building a mix.
∙Connect the mix or monitor outputs to your power amplifiers and speakers and set the gain of the amplifiers to about 70%. Move the Master Faders gradually to the top, listening carefully for any hint of feedback or overload. You may find that the input gain settings will need to be edged back slightly as the mix is built up.
∙Listen carefully for the characteristic sound of ‘feedback’. If you cannot achieve a satisfactory input level setting without feedback, adjust microphone and speaker positions and try again.
Careful microphone placement and the choice of a suitable type of microphone is essential for successful PA use. The aim should be to place the microphone as close as possible to the source, to cut out unwanted surrounding sounds. This allows a lower gain setting on the mixer and helps to avoid feedback. You will also find that a
SPIRITFOLIO4 |
11