VIZIO VP50HDTV User Manual
g.Press the 
button until Auto Scan is highlighted.
h.Use the 
button to start the search. When finished, “Auto Scan Completed” will be displayed at the top of the screen. Note: This will take a few minutes to complete.
i.To add or delete a channel press the 
button to highlight CH and then press the 
or 
buttons until the desired channel number is shown.
j.Press the 
button to highlight Set Channel and then press the button the select this
option. Use the 
or 
buttons to Add or Skipped.
k.Press the MENU button repeatedly to exit the On Screen Display (OSD).
6.Using DTV with an Antenna or Cable
To use the Digital TV option, you will need to select DTV using the INPUT button on the remote or side of the Plasma TV, or directly by pressing the TV button on the Remote Control. The first time you use your DTV input you will see the information panel, “Channel Scan Required Press Menu” Press the MENU button and follow the procedure in Section 3.4 DTV
Tuner Setup. Note: DTV digital broadcast is not available in all areas. Refer to www.antennaweb.org to get information about availability in your area, type of antenna and in which direction to point your antenna. The channel availability through cable depends upon which channels your cable operator supplies in Clear QAM; consult your cable operator for more information.
7.Using a PC
If connecting to a PC through the RGB PC input, set the TV timing mode to VESA 1024x768 at 60Hz for best picture quality (refer to the graphic card’s user guide for questions on how to set this timing mode).
Version 4/17/2007 | 30 |
| www.VIZIOCE.com |