Muting the Beep Tone
Press the 6 button while pressing the SEL button.
To reactivate the beep tone, press these buttons once more.
Note
When connecting an optional power amplifier to the LINE OUT, the beep tone is disabled.
Turning on the Clock
Display — Power Select Function
Only for cars with accessory position on the ignition key switch.
To turn the Power Select Function on Press the OFF button while pressing the SEL button.
To turn the accessory position ON or OFF, the clock will be displayed or not.
To avoid battery wear, the clock is not displayed when the unit is initialization.
Maintenance
Fuse Replacement
When replacing the fuse, be sure to use one matching the amperage rating stated on the fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer.
Fuse (15 A)
Dismounting the Unit
1 While pushing in on the left side of the front cover, insert the tip of a thin screwdriver as shown in the illustration, then pry off the front cover.
Thin screwdriver
(Be careful to not break the front cover.)
2 Repeat step 1 on the right side. Then the front cover will be removed.
3 Use a thin screwdriver to push in the clip on the left side of the unit, then pull out the left side of the unit until the catch clears the mounting.
4 Repeat step 3 on the right side.
EN
Radio Reception/Other Functions
Warning
Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit.
5 Slide the unit out of the mounting.
9
Actual total number: | Sony |
|
|