Toshiba SD-P1600 manual Loading the remote control battery, Operating with the remote control

Loading the remote control battery

1 Gently insert a fingernail in groove 1 and pull out the holder in direction 2 .

Backside

1

2

Take care not to break your fingernail.

2 Place a coin-shaped battery (CR2025)

with the side up on the holder.

CR20253V

Keep the holder horizontal so that the battery does not fall through.

3 Push the holder back into its receptacle.

Backside

Notes on coin-shaped batteries

•If the remote control does not function correctly or if the operating range becomes reduced, replace the battery with new one.

• See 6 for safety use of coin-shaped batteries.

•Inserting a battery other than the specified one or an

object may damage the remote control.

Operating with the remote control

Point the remote control at the remote sensor on the player and press the buttons.

Within about 3 m (9.9 feet)

Distance: About 3 m (9.9 feet) from the front of the remote sensor

Angle: About 30° in each direction of the front of the remote sensor

*Do not expose the remote sensor of the player to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the player via the remote control.

Notes on the remote control

•Aim the remote control at the remote sensor of the player.

•Do not drop or give the remote control a shock.

•Do not leave the remote control near an extremely hot or humid place.

•Do not spill water or put anything wet on the remote control.

•Do not disassemble the remote control.

Introduction

15

SD-P1600_E_P02-16 15 05.1.14, 10:42 AM