Toshiba SD-43HT owner manual Troubleshooting, Language Code List, Symptom Cause Correction

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.

Symptom	Cause	Correction
No power.	• The power cord is disconnected.	• Plug the power cord into the wall outlet
		securely.
The power is on, but	• No disc is inserted.	• Insert a disc. (Check that the DVD or,
the DVD receiver		audio CD indicator in the display
does not work.		window is lit.)
No picture.	• The TV is not set to receive DVD signal	• Select the appropriate video input mode
	output.	on the TV so the picture from the DVD
		receiver appears on the TV screen.
	• The video cable is not connected	• Connect the video cable into the jacks
	securely.	securely.
	• The connected TV power is turned off.	• Turn on the TV.
No sound.	• The equipment connected with the	• Select the correct input mode of the
	audio cable is not set to receive DVD	audio receiver so you can listen to the
	signal output.	sound from the DVD receiver.
	• The audio cables are not connected	• Connect the audio cable into the jacks
	securely.	securely.
	• The power of the equipment connected	• Turn on the equipment connected with
	with the audio cable is turned off.	the audio cable.
	• The Digital Audio Output is set to the	• Set the Digital Audio Output to the correct
	wrong position.	position, then turn on the DVD receiver
		again by pressing On/standby(	).
The playback	• The disc is dirty.	• Clean the disc.
picture is poor.
The DVD receiver	• No disc is inserted.	• Insert a disc. (Check that the DVD, or audio
does not start		CD indicator in the DVD display is lit.)
playback.	• An unplayable disc is inserted.	• Insert a playable disc. (Check the disc
		type, color system and Regional code.)
	• The disc is placed upside down.	• Place the disc with the playback side
		down.
	• The disc is not placed within the guide.	• Place the disc on the disc tray correctly
		inside the guide.
	• The disc is dirty.	• Clean the disc.
	• The Rating level is set.	• Cancel the Rating function or change
		the rating level.
The remote control	• The remote control is not pointed at the	• Point the remote control at the remote
does not work	remote sensor of the DVD receiver.	sensor of the DVD receiver.
properly.
	• The remote control is too far from the	• Operate the remote control within about
	DVD receiver.	23 ft (7 m).
	• There is an obstacle in the path of the	• Remove the obstacle.
	remote control and the DVD receiver.
	• The batteries in the remote control are	• Replace the batteries with new ones.
	exhausted.

Language Code List

Enter the appropriate code number for the initial settings “Disc Audio”, “Disc Subtitle” and/or “Disc Menu” (See page 32).

MISCELLANENOUS

43 44