Toshiba HD-A35KU, HD-A35KC owner manual Audio

Page 34

Customizing the function settings (Continued)

Picture Mode

There are two types of source content in pictures recorded in DVD video discs: film content (pictures recorded from films at 24 frames per second) and video content (video signals recorded at 30 frames per second). Make this selection according to the type of content being viewed.

Film

Video

Auto

The player converts film content pictures in the progressive output format appropriately. Suitable for playback of film content pictures.

The player filters video signal, and converts it in the progressive output format appropriately. Suitable for playback of video content pictures.

Select this position normally. The player automatically detects source content, film or video, of playback source, and converts that signal in the progressive output format in an appropriate method.

Note

The player may not be able to detect the source (film or video) of some material. If you notice undesirable picture performance, try selecting “Film” or “Video”.

Resolution Setting

See page 21.

Audio

Digital Out SPDIF

See page 22.

Digital Out HDMI

See page 22.

Digital Direct Audio Mode

To output high bitrate audio to a connected amplifier equipped with Dolby Digital Plus, Dolby TrueHD or DTS-HD decoder.

On

Off

High bitrate audio output is enabled. (Sub audio and effect audio are disabled.)

High bitrate audio output is disabled.

Notes

This selection is available only when the player is connected to an amplifier equipped with Dolby Digital Plus, Dolby TrueHD or DTS HD decoder.

To obtain high bitrate audio output, “Digital Out HDMI” ( page 22) needs to be set to “Auto”.

Dynamic Range Control

To turn on or off a function that makes faint sounds easier to hear even if you lower the volume during late-hour playback.

Auto

On

Off

While playing an HD DVD video disc recorded in Dolby TrueHD format, this function will be automatically activated or disabled according to certain command included in the content. For other discs, this function is activated.

This function is activated.

This function is disabled.

Notes

This function is effective only in playback of HD DVD or DVD video discs recorded in Dolby Digital, Dolby Digital Plus or Dolby TrueHD format.

The effect level of this function vary depending on the disc.

Not effective in Dolby TrueHD 96 kHz 5.1 channel sound.

34

HD-A30KUKC_en.indd 34

07.7.26 3:01:12 PM

Image 34
Contents HD-A35KU HD-A35KC This HD DVD player employs a Laser System ProcedureResult in hazardous radiation exposure Location of the required label Important Safety Instructions Precautions Do not use the unit when moisture condensation may occur Moisture condensation occurs during the following casesTable of contents Disc compatibility FeaturesDisc Specification Certain system requirements Important notes about HD DVDHD output jacks Customer supportFront panel Index to parts and controlsRear panel Remote control DisplaySupplied accessories AccessoriesRemote control Loading batteriesRelease TV CODE. The brand code is memorized To program the remote control to operate your TVTV control While holding down, enter a codePreparation Resolution and connectionsWhy Hdmi connection is most recommended? Proceed the following steps to set the player readyVia component video input Connecting to a TVVia Hdmi input Via Video yellow inputVia optical digital audio output Connecting to audio systemVia Hdmi output Via 5.1ch analog audio outputLAN connection Via analog audio outputWhich the player is connected to Power connectionPowering on Press ON/STANDBYSetting up the player LanguageConfirm the time is correct TimePress / to select Clock Set, then press If the time is correct, select OK byPress / to select Picture, then press OK ResolutionPress To select Resolution Setting, then press OK Below, then press OKAudio output Press / to select Audio, then press OKFront Left / Front Right When a 2ch stereo system is connected to this playerCrossover Setting Center / L Surround / R SurroundEthernet To adjust the player’s clock via the network time protocolTo select whether you access Cookies or not To set your network informationCookie Setting Network SpeedPlaying a disc PlayingPlayback starts If playback does not start, press Play To resume playback from the location last stopped To pause playbackTo stop playback To change playback speedTo select the camera angle To select subtitlesTo select the sound During playback, press SubtitleTo play repeatedly To locate a positionTo check the current status C/D buttons Requirements for HD DVD discs/Web-enabled network contentHD DVD playing options in the future Cursor controlsOutput sound conversion table Setup Menu appears Customizing the function settingsDuring stop, press Setup Group Setting Disc DetailsSettings PictureAudio Language Language code list How to select a languageEthernet GeneralMaintenance Remote Controller Sound OffEnable Hdmi Update FirmwareBefore calling service personnel Symptom RemedySpecification Memo Commercial Units Limited One 1 Year Warranty on PartsRental Units Your ResponsibilityHow to Obtain Warranty Services Rental Units Limited Canadian Warranty For Toshiba Brand HD DVD PlayersLimited Warranty for Commercial Units Your ResponsibilityHow to Obtain Warranty Services Arbitration and Dispute ResolutionGeneral Provisions Information on Customer Support