Setting up your devices
Example: to set up the TOTAL CONTROL for your Television:
1Find your device code in the code section (page 12 – 25). Codes are listed by brand name. The most popular
code is listed first. Make sure your television is switched on (not on standby).
2Press and release the TV key on your TOTAL CONTROL.
TV
3Press and hold down the SET key until the red light blinks
twice (the red light will blink once and then twice). | SET |
4Enter your
| The red light will blink twice. | _ _ _ _ | ||
|
|
|
| |
|
|
|
| |
5 | Now, aim your TOTAL CONTROL at your television and | POWER | ||
| press POWER. If your television switches off, your TOTAL |
|
|
|
| CONTROL should be ready to control your television. |
|
|
|
|
|
|
|
|
-If your device does not respond, follow steps 1 through 5 with each code listed for your brand. If none of the codes listed for your brand operate your device, then try the Search Method described on page 7, even if your brand is not listed at all.
-Some codes are quite similar. If your device does not respond or is not functioning properly with one of the codes, try another code listed under your brand.
-If the original remote control from your Video Recorder did not have a Power key, press PLAY instead of POWER during step 5.
-To set up your other devices, follow the same instructions above, only press the appropriate device key during step 2.
-Write your code in the boxes provided in the battery compartment and on page 8, for quick, easy reference.
Devices can be found under the following keys:
Television | Satellite- |
Receiver / | |
| Cable- |
| Converter |
TV | SAT |
| |
Video Recorder/ |
| (*) Television | |
DVD |
| ||
| (*) Video Recorder/ | ||
VCR/ | AUX | ||
DVD | |||
DVD | |||
| |||
|
| (*) Satellite- | |
|
| Receiver / | |
|
| Cable- | |
|
| Converter |
-To set up a second TV, VCR/DVD or SAT see page 9.
-(*) To use the AUX key see page 9.
6