2.Press FAV once.
•If Favorite Channel Scan has been set up,scanning of favorite channels will start with up to 100 channel changes or until stopped by pressing any key.
•If Favorite Channel Scan has not been set up, scanning will start with the current channel, and continue up to 100 channel changes or until stopped by pressing any key.
3.To stop scanning channels at any time, press any key once.
PROGRAMMING FAVORITE CHANNEL SCAN
In the CBL/SAT or TV mode, you can store a list of up to 10 favorite channels, in any order, that will be immediately scanned when FAV is pressed (see Using Channel Scan on the previous page).
NOTE: Favorite channels can only be programmed for one mode. After programming, if FAV is pressed while in another mode, the remote control will start scanning all channels instead (if applicable to the selected device).
1.On the remote control, press CBL/SAT or TV once.
2.Press and hold SET until the LED (red light) blinks twice, then release SET.
3.Enter 9 - 9 - 6. The LED will blink twice.
4.Use the keypad to enter a favorite channel number (e.g., 031). Then press SET once.
NOTE: If the original remote control required pressing an Enter key to change the channel, also press the ENTER key after the channel number (e.g., 0 - 3 - 1 - ENTER). On some satellite receivers and cable
boxes, you may need to press the SELECT (OK) key instead of ENTER.
5.If desired, repeat step 4 for each channel to be stored, up to a total of 10 channels.
NOTE: If you try entering more than 10 channels, the remote control will automatically exit programming. To change your favorite chan- nel list at this point, you will first need to delete the existing list by performing the steps in “Clearing Custom Programming” on page 14. Then, perform the instructions in this section once again.
6.To exit programming with less than 10 favorite channels stored, press and hold SET until the LED blinks twice. Otherwise, the remote control will automatically exit the program after 10 channels have been stored.
12