TROUBLESHOOTING
PROBLEM: | LED (red light) does not blink when you press a key. |
SOLUTION: | Replace batteries with two new AAA alkaline batteries. |
PROBLEM: | LED blinks when you press a key, but home entertain- |
| ment device does not respond. |
SOLUTION: | Make sure the remote control is aimed at your home |
| entertainment device and is not farther than 15 feet |
| away. |
PROBLEM: | The unit does not control home entertainment devices |
| or commands are not working properly. |
SOLUTION: | Try all listed codes for the device brands being set up. |
| Make sure they can be operated with an infrared remote |
| control. |
PROBLEM: | Changing channels does not work. |
SOLUTION: | If original remote required pressing ENTER or SELECT to |
| change channels,press ENTER or SELECT on this remote |
| after entering the channel number. |
PROBLEM: | Tried Searching For Your Code method and still could |
| not find a working code. |
SOLUTION: | Clear the device key as follows: Press and hold SET until |
| the LED (red light) blinks twice, then release. Next enter |
| 9 - 9 - 2. Then press the device key to be cleared twice. |
| Now repeat the Searching For Your Code method on |
| page 9. |
PROBLEM: | CH▲ and CH▼do not work for your RCA TV. |
SOLUTION: | Due to RCA design |
| remote control will operate these functions. |
PROBLEM: | No remote control of volume. |
SOLUTION: | See Changing Volume Lock on page 13 to lock/unlock |
| volume. |
For additional information: | |
• | Internet: http://www.oneforall.com |
15