Toshiba SD-R5002 Front Panel Loading Tray Busy Light, Eject Button Emergency Eject Hole

Page 4

Front Panel

Loading

Tray

Busy Light

LED

Eject

Button

Emergency Eject Hole

Figure 1.SD-R5002 DVD Writeable Drive Front Panel

Load disc using tray.

The LED lights green or amber when the drive is operating (LED is amber when drive is writing.)

The Eject button is used to open the disc tray so you can install or remove a disc.

The emergency eject hole is to be used only when the Loading Tray will not open when Eject button is pressed.

System Requirements

The DVD Writeable kit requires the following (If kit uses Nero6 software):

Microsoft Windows 98SE, XP, 2000 or ME

CPU Requirements: 300MHz minimum

800MHz for capturing to hard disc 1.6GHz for capturing to DVD video

64MB RAM, 128MB RAM (for video editing)

Hard Drive Space: 500MB minimum 4.8GB for DVD Images

Screen solution 800 x 600 pixel minimum, 16 bit color depth or higher

Windows Internet Explorer 4.0 or higher

PCI sound card, USB audio box or motherboard built-in audio device

TV tuner or video capture board for analog recording

Image 4
Contents DVD Rewriteable Drive Contents Types of Disc Formats Supported Write Introduction SD-R5002Types of Disc Formats Supported Read Eject Button Emergency Eject Hole Front Panel Loading Tray Busy LightSystem Requirements Setup SD-R5002 Jumper SettingsConnecting Cables Placing DVD Rewriteable Drive inside your ComputerInstalling Power Cable Completing InstallationPage Drive Operation Inserting a Disc Horizontally Inserting a Disc VerticallySoftware Removing a DiscMedia Recommendations Cleaning Media Usage GuidelinesEmergency Ejection Handling MediaTroubleshooting SD-R5002 SolutionSpecifications -SD-R5002 GeneralPerformance CD-ROM, CD-R CD-RWPower ConnectorsReliability EnvironmentalRegulatory Drive Connectors -SD-R5002 ConnectorMode Select AudioInterface Pin Assignments
Related manuals
Manual 18 pages 23.79 Kb