Toshiba user manual Setup SD-R5002, Jumper Settings

Page 5

SETUP – SD-R5002

The following steps must be performed to properly install your drive:

Set Drive Jumper Settings

Connect Audio Cable

Attach IDE BUS Cable

Attach Power Cable

Mount Drive

Jumper Settings

The mode select jumpers are 6 straight angle pins located on the rear of the DVD Rewriteable drive. By placing a jumper on the pins, you can select the following functions:

CS

Drive is configured using host interface signal CSEL

SL

Configures drive as Slave

MA

Configures drive as Master (default mode)

 

Figure 1.Mode Select Jumper

In most installations, jumper should remain in the MA position (factory default). It is recommended that you install your DVD Rewriteable drive only on the secondary IDE BUS. If you are installing on primary IDE BUS, your hard drive would then be the Master, and you should set your DVD Rewriteable drive to the Slave position (SL)

Figure 2.Jumper Locations

3

Image 5
Contents DVD Rewriteable Drive Contents Types of Disc Formats Supported Read Introduction SD-R5002Types of Disc Formats Supported Write System Requirements Front Panel Loading Tray Busy LightEject Button Emergency Eject Hole Jumper Settings Setup SD-R5002Placing DVD Rewriteable Drive inside your Computer Connecting CablesCompleting Installation Installing Power CablePage Inserting a Disc Vertically Drive Operation Inserting a Disc HorizontallyMedia Recommendations Removing a DiscSoftware Usage Guidelines Cleaning MediaEmergency Ejection Handling MediaSolution Troubleshooting SD-R5002General Specifications -SD-R5002CD-ROM, CD-R CD-RW PerformanceConnectors PowerReliability EnvironmentalRegulatory Connector Drive Connectors -SD-R5002Mode Select AudioInterface Pin Assignments
Related manuals
Manual 18 pages 23.79 Kb