Toshiba SD-P4000 Lightning, Power Lines, Overloading, Object and Liquid Entry, Servicing, Heat

Page 4

Introduction

IMPORTANT SAFEGUARDS

(continued)

 

 

 

13.

LIGHTNING

 

 

To protect your unit from a lightning storm, or when it is left unattended and unused for long periods of time,

 

unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the

 

unit due to lightning and power line surges.

 

14.

POWER LINES

 

 

An outside antenna system should not be located in the vicinity of overhead power lines or other electric

 

light or power circuits, or where it can fall onto or against such power lines or circuits. When installing an

 

outside antenna system, extreme care should be taken to keep from touching such power lines or circuits,

 

as contact with them might be fatal.

 

15.

OVERLOADING

 

 

Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock.

16.

OBJECT AND LIQUID ENTRY

 

 

Do not push objects through any openings in this unit, as they may touch dangerous voltage points or short

 

out parts that could result in fire or electric shock. Never spill or spray any type of liquid into the unit.

17.

OUTDOOR ANTENNA GROUNDING

 

 

If an outside antenna or cable system is connected to the unit, be sure the antenna or cable system is

 

grounded to provide some protection against voltage surges and built-up static charges, Section 810 of the

 

National Electrical Code (NEC), ANSI/NFPA 70, provides information with respect to proper grounding of

 

the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of

 

grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and require-

 

ments for the grounding electrode.

 

18.

SERVICING

 

 

Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous

 

voltage or other hazards. Refer all servicing to qualified service personnel.

 

 

For example:

 

 

a. When the power-supply cord or plug is damaged.

 

 

b. If liquid has been spilled, or objects have fallen into the unit.

 

 

c. If the unit has been exposed to rain or water.

 

 

d. If the unit does not operate normally by following the operating instructions. Adjust only those

 

 

controls that are covered by the operating instructions, as an improper adjustment of other controls

 

 

may result in damage and will often require extensive work by a qualified technician to restore the

 

 

unit to its normal operation.

 

 

e.

If the unit has been dropped or the cabinet has been damaged.

 

 

f.

When the unit exhibits a distinct change in performance, this indicates a need for service.

19.

REPLACEMENT PARTS

 

 

When replacement parts are required, be sure the service technician uses replacement parts specified by

 

the manufacturer or those that have the same characteristics as the original part.

 

 

Unauthorized substitutions may result in fire, electric shock or other hazards.

 

20.

SAFETY CHECK

 

 

Upon completion of any service or repairs to this unit, ask the service technician to perform safety checks to

 

determine that the unit is in proper operating condition.

 

21.

HEAT

 

 

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other

 

products (including amplifiers) that produce heat.

 

22.

DISC SLOT

 

 

Keep your fingers well clear of the disc slot as it is closing. It may cause serious personal injury.

23.

CONNECTING

 

 

When you connect the product to other equipment, turn off the power and unplug all of the equipment from

 

the wall outlet. Failure to do so may cause an electric shock and serious personal injury. Read the owner's

 

manual of the other equipment carefully and follow the instructions when making any connections.

24.

SOUND VOLUME

 

 

Reduce the volume to the minimum level before you turn on the product. Otherwise, sudden high volume

 

sound may cause hearing or speaker damage.

 

25.

SOUND DISTORTION

 

 

Do not allow the product output distorted sound for a longtime. It may cause speaker overheating and fire.

26.

HEADPHONES

 

 

When you use the headphones, keep the volume at a moderate level. If you use the headphones continu-

4

ously with high volume sound, it may cause hearing damage.

J5N00201A [E] (P02-05)

4

6/8/04, 7:14 PM

Image 4
Contents SD-P4000 Important Safeguards IntroductionCleaning AccessoriesPower Source POWER-CORD ProtectionPower Lines Replacement PartsSafety Check ConnectingDisc Laser BeamLCD Precautions  Do not use the unit when moisture condensation may occurTo obtain a clear picture WaitOn cleaning discs Structure of disc contentsOn handling discs On storing discsPlayable discs On Video CDsDVD Contents Top Identification of controlsFront Adjusting the angle of the base SideRear Left SideRemote control DVD Menu buttonInserting batteries OperationAntenna connections ConnectionsCable TV connections ConnectionsConnecting to optional equipment VCRLeft side Camcorderred Line Selecting Component input mode Connecting to an optional equipment with S-video outputEx. VCR with S-Video Connecting to an amplifier equipped with a DTS decoder Dolby DigitalRear lower right of TV/DVD Dolby Surround Pro LogicMPEG2 sound Channel digital stereoPower connection Power sourceTo USE AC Power Setting the language Setting the languageBasic setup Automatic memory tuning To memorize channelsTV/CABLE selection To ADD/DELETE channelsTV operation TV operationTV operation Set the TV/CABLE selection to the appropriate position Game Mode  Headphones Channel UP/DOWN  RecallWhat is Closed CAPTIONING? Closed captionsClosed captions To View Closed CaptionsTo register password Setting the V-ChipTo change password To set the V-Chip OFFTV-Y TV-GPicture control adjustment Adjusting the picture preference Picture control adjustmentAdjusting the picture preference Mode Picture qualitySelecting the color temperature Selecting the color temperatureCool MediumSound control adjustment Listening to stereo soundListening to SAP Second Audio Program To select desired sound To start playback in the stop mode Playing a discVcdcd Basic playback Basic playbackTo pause playback still mode To remove the disc To obtain a higher quality pictureAbout To stop playbackVCD Playing in fast reverse or fast forward directions Dvdvcd Playing frame by frameDVD Playing in slow-motion VCD Locating a chapter or trackCancel Zooming/Locating desired sceneDvdvcd Zooming Locating desired sceneVCD Repeat playback Repeat playback/A-B Repeat playbackVCD A-B Repeat playback Program playback Program playback/Random playbackCD Random playback Changing angles/Title selection/DVD menu Changing anglesTitle selection DVD menuChanging soundtrack language/ Subtitles Dvdvcd Changing soundtrack language SubtitlesKaraoke playback/Disc status To turn off the PBCKaraoke playback Disc statusMP3/WMA/JPEG CD operation CD MP3/WMA/JPEG CD informationCD MP3/WMA CD playback Press Enter5Press Stop to end playback About file menuCD Jpeg CD playback CD Slide show playbackPress Stop to end playback PreparationCustomizing the function settings VCD Setting procedureFunction setup Press Setup during stop modeSetting details Parental control setting If you forget the passwordDRC To change the parental levelPlayback will commence if the entered password was correct Temporary disabling of rating level by DVD discLoad a DVD disc and press Play Then press EnterOthers Language code listOthers Symptoms Possible Solutions Power TroubleshootingTV Broadcast Reception Remote Control Symptoms Possible Solutions DVD About the LCD Reception disturbances IgnitionSpecifications Rental Units How to Obtain Warranty Services 04/06 U