Troubleshooting
Before calling a service technician, please check the following table for a possible cause of the problem and some solutions.
Problem | Solution | |
TV will not turn on | • | Make sure the power cord is plugged in, then press POWER. |
| • | The remote control batteries may be dead. Replace the batteries. |
No picture, no sound | • | Check the antenna/cable connections. |
No sound, picture OK | • | The sound may be muted. Press VOLUME. |
| • The station may have broadcast difficulties. Try another channel. | |
Poor sound, picture OK | • | The station may have broadcast difficulties. Try another channel. |
Poor picture, sound OK | • | Check the antenna connections. |
| • The station may have broadcast difficulties. Try another channel. | |
| • | Adjust the PICTURE menu. |
Poor reception of broadcast channels | • | The station may have broadcast difficulties. Try another channel. |
| • | Check the antenna connections. |
| • If you are using a VCR, make sure the TV/VCR button is set correctly. | |
Cannot receive above channel 13 | • | Make sure TV/CABLE is set to CABLE mode. |
Unable to select a certain channel | • | The channel may be blocked out with the |
|
| with the add/erase feature. |
Multiple images | • | The station may have broadcast difficulties. Try another channel. |
| • | Use a highly directional outdoor antenna. |
Poor color or no color | • | The station may have broadcast difficulties. Try another channel. |
| • Adjust the TINT and/or COLOR in the PICTURE menu. | |
| • If you change the direction of the TV while it is turned on, the picture | |
|
| could suffer from color shading. If so, turn off the TV and allow it to cool |
|
| down for several hours before turning it on again. |
No stereo or SAP sound from a | • | Make sure the MTS feature is set properly. |
known MTS broadcast |
|
|
The remote control does not operate | • | Check if the TV/VCR/CABLE mode is properly set. |
| • | There may be an obstruction between the remote control and the |
|
| remote control sensor. |
| • | The remote control batteries may be dead. Replace the batteries. |
The | • | Change or reset your PIN code (see page 14, Selecting a PIN code). |
Welcome to Toshiba
Important | Safeguards |
Connecting your TV
Using the Remote Control
Setting up your TV
25
Using the TV’s Features
Appendix
Appendix
3J70201B | 25 | 28/5/01, 2:25 PM |