Toshiba 14AF41 appendix Lightning, Heat

Page 5

13.LIGHTNING

To protect your unit during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the unit due to lightning and power line surges.

14.POWER LINES

An outside antenna system should not be located in the vicinity of overhead power lines, or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

15.OVERLOADING

Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

16.OBJECT AND LIQUID ENTRY

Do not push objects through any openings in this unit as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid into the unit.

17.OUTDOOR ANTENNA GROUNDING

If an outside antenna or cable system is connected to the unit, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna dis- charge unit, connection to grounding electrodes, and requirements for the grounding electrode.

18.SERVICING

Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

19.DAMAGE REQUIRING SERVICE

Unplug this unit from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power-supply cord or plug is damaged.

b.If liquid has been spilled, or objects have fallen into the unit.

c.If the unit has been exposed to rain or water.

d.If the unit does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the unit to its normal operation.

e.If the unit has been dropped or the cabinet has been damaged.

f.When the unit exhibits a distinct change in performance, this indicates a need for service.

20.REPLACEMENT PARTS

When replacement parts are required, be sure the service technician uses replacement parts specified by the manu- facturer or those that have the same characteristics as the original part.

Unauthorized substitutions may result in fire, electric shock or other hazards.

21.SAFETY CHECK

Upon completion of any service or repairs to this unit, ask the service technician to perform safety checks to determine that the unit is in proper operating condition.

22.HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

23.NOTE TO CATV SYSTEM INSTALLER

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE

Welcome to Toshiba

Important

Safeguards

Connecting your TV

Using the Remote Control

Setting up your TV

GROUND CLAMP

ELECTRIC

SERVICE

EQUIPMENT

NEC-NATIONAL ELECTRICAL CODE

S2898A

ANTENNA LEAD IN WIRE

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

GROUNDING CONDUCTORS

(NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H)

Using the TV’s Features

Appendix

3

3J70201B P01-03

5

28/5/01, 2:23 PM

Image 5
Contents 14AF41 Exploring your new TV Welcome to ToshibaSelecting a location for the TV Model number Serial numberImportant Safeguards Connecting your TV All operating and use instructions should be followed Important SafeguardsHeat LightningConnecting a VCR Connecting your TVColorStream compatible components Stereo VCRConverter/ Descrambler Splitter Switch a B Connecting a cable converter boxConnecting a DVD with ColorStream and a VCR Connecting a DVD/satellite receiver and a VCRConnecting a camcorder Connecting two VCRsConnecting an audio amplifier You will need One pair of audio cables One video cablePreparing the remote control for use Using the remote controlInstalling the remote control batteries Using the remote control with a VCR or a cable TV converterVCR Registration codes by product and brand name100 Learning about the remote controlChanging the on-screen display language Setting up your TVTo select a language Press or to highlight your desired languageChanging channels Adding channels to the TV’s memoryProgramming channels automatically Adding and erasing channels manuallyAdjusting the channel settings Using the TV’s featuresSwitching between two channels Programming your favorite channelsTo select your PIN code and access the V-Chip menus Using the V-ChipSelecting a PIN code To clear your favorite channelsPress to or display the V-CHIP menu Blocking programs by ratingsTo change your PIN code Press Exit to return to normal viewingTV Ratings Mpaa RatingsYouth TV Ratings Dialog Rating To use the V-Chip to block programs by ratingBlocking channels Blocking unrated movies or programsTo block unrated movies or programs To block channelsTo unblock channels Labeling channelsTo create channel labels Press or to highlight LabelTo erase channel labels Adjusting the picture qualityTo adjust the picture quality Setting the sleep timer Selecting the ColorStream modeUsing the closed caption feature Watching video inputMuting the sound Adjusting the soundSelecting stereo/SAP broadcasts Press the MTS button to select the desired soundUsing the Stable Sound feature Adjusting the sound qualityTo adjust the sound quality To turn on the Stable Sound featureUnderstanding the Power Return feature Auto power offCleaning and care To clean the TV screenDown for several hours before turning it on again TroubleshootingProblem Solution VIDEO/AUDIO Input SpecificationsLimited United States Warranty Continental U.S If your TV requires service, call toll free 1-800-631Limitations Hawaii3J70201B P22-BACK 28/5/01, 225 PM 3J70201B 01/06 23563690