Chapter 8: Troubleshooting
General troubleshooting
Before calling a service technician, please check this chapter for a possible solution to the problem
experienced.
Black box on-screen
•• The closed caption feature is set to one of the Text modes (T1, T2, T3, or T4). Set the closed caption feature to Off ( page 36).
TV stops responding to controls
•• If the TV stops responding to the remote control or TV control panel and you cannot turn off the TV, please unplug the power cord for a few seconds then plug it back in and try again.
Other problems
•• If your TV’s problem is not addressed in this Troubleshooting section or the recommended solution has not worked, use the Restore Factory Defaults procedure ( page 27).
TV will not turn on
•• Make sure the power cord is plugged in, and then press Power /
.
•• The remote control batteries may be dead. Replace the batteries or try the control panel buttons.
Picture problems
General picture problems
•• | Check the antenna/cable connections ( Chapter | |
| 2). |
|
•• | Press | on the remote control or TV and |
select a valid video input source ( page 28). If no device is connected to a particular input on the TV, no picture will display when you select that particular input source. For device connection details, see Chapter 2.
•• Antenna reception may be poor. Use a highly directional outdoor antenna (if applicable).
•• The station may have broadcast difficulties. Try another channel.
•• Adjust the picture qualities ( page 35).
Noisy picture
•• If you are watching an analog channel (off- air broadcast or Cable TV), you can set the CableClear® feature to reduce visible interference in the TV picture ( page 51).
Video Input Selection problems
•• If the Input Selection window does not appear
when you press | on the remote control or | |
TV, press | a second time. This will cause a | |
change to the next video input source and display the Input Selection window.
Cannot view external signals or channel 3 or 4
•• If you cannot view signals from external devices connected to VIDEO, ColorStream® HDMI 1, HDMI 2, PC or from channels 3 or 4, make sure the Input Lock is set to Off ( page 41).
Poor color or no color
•• The station may have broadcast difficulties. Try another channel.
•• Adjust the Tint and/or Color ( page 35).
Poor composite picture
•• If the TV is connected to an external A/V device (e.g., DVD player, video game system,
Picture and sound are out of sync
•• As with all products that contain a digital display, in rare instances, when viewing certain content (e.g.. television broadcasts, video games, DVDs), you may notice that the sound and picture are slightly out of sync. This phenomenon can be caused by various factors including, without limitation, video processing within the TV, video processing in an attached gaming system, and video processing or different compression rates used by broadcasters in their programming. You may want to try one or more of the following suggestions, which may help to reduce the effect of this phenomenon:
––If the TV is connected to an A/V receiver that has a programmable audio delay feature, use this feature to help synchronize the sound to the picture.
––If you notice this phenomenon only on certain TV channels, please contact your local broadcast, cable, or satellite provider to inform them of this issue.
52