Toshiba 42HP86, 50HP86 appendix Care

Page 4

Introduction

Installation (cont. from previous page)

26)Always make sure the antenna system is properly grounded to provide adequate protection against voltage surges and built-up static charges (see Section 810 of the National Electric Code).

 

Antenna

 

lead-in wire

Ground clamp

 

 

Antenna discharge unit

Electric service

(NEC Section 810-20)

Grounding conductors

equipment

(NEC Section 810-21)

 

Power service grounding

Ground clamps

 

electrode system

 

(NEC Art 250 Part H)

 

27)

DANGER: RISK OF SERIOUS

 

PERSONAL INJURY OR DEATH!

 

• Use extreme care to make sure you

are never in a position where your body (or any item you are in contact with, such as a ladder or screwdriver) can accidentally touch overhead power lines. Never locate the antenna near overhead power lines or other electrical circuits.

Never attempt to install any of the following during lightning activity: a) an antenna system; or b) cables, wires, or any home theater component connected to an antenna or phone system.

Care

For better performance and safer operation of your TOSHIBA TV, follow these recommendations and precautions:

28)If you use the TV in the room of 0˚C or less, the picture brightness may vary until the plasma monitor warms up. This is not a sign of a malfunction.

29)Always unplug the TV before cleaning. Wipe the display panel surface

gently using only the supplied

wiping cloth or a soft cloth (cotton, flannel, etc.) A hard cloth

may damage the surface of the panel. Avoid contact with alcohol, thinner, benzene, acidic or and alkaline solvent cleaners, abrasive

cleaners, or chemical cloths, as the surface may be impaired.

30)WARNING: RISK OF ELECTRIC SHOCK! Never spill liquids or push objects of any kind into the TV cabinet slots.

Care (cont. from previous column)

31)While it is thundering, do not touch the connecting cables or apparatus.

32)For added protection of your TV from lightning and power surges, always unplug the power cord and disconnect the antenna from the TV if you leave the TV unattended or unused for long periods of time.

33)During normal use, the TV may make occasional snap- ping or popping sounds. This is normal, especially when the unit is being turned on or off. If these sounds become frequent or continuous, unplug the power cord and contact a Toshiba Authorized Service Center.

34)Possible Adverse Effects on Plasma Display If a fixed (non-moving) pattern or image remains on the Plasma display for extended periods of time, the image can become permanently ingrained in the plasma panel of the TV and cause subtle but permanent ghost images. This type of damage is NOT COVERED BY YOUR WARRANTY.

Never leave the Plasma TV on for extended periods of time while it is displaying the following images or formats:

Fixed (non-moving) images, including but not limited to PIP/POP windows, closed captions, video game patterns, TV station logos, stock tickers, and websites.

Special formats that do not use the entire screen, including but not limited to widescreen or letterbox format media viewed on a 4:3 aspect ratio display (with gray or black bars at the

top and bottom of the screen)

and 4:3 aspect ratio format media viewed on a widescreen/16:9

aspect ratio display (with gray or

black bars on the left and right sides of the screen.)

Service

35)WARNING: RISK OF ELECTRIC SHOCK!

Never attempt to service the TV yourself. Opening and removing the covers may

expose you to dangerous voltage or other hazards. Refer all servicing to a Toshiba Authorized Service Center.

36)If you have the TV serviced:

Ask the service technician to use only replacement parts specified by the manufacturer.

Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

37)When the TV reaches the end of its useful life, ask a qualified service technician to properly dispose of the TV.

4

30A0121A_En_p02-09

4

5/26/06, 6:24 PM

Image 4
Contents 42HP86 50HP86 Child Safety Important Safety Instructions Care Important notes about your Plasma TV Connecting your TV Setting up your TVUsing the TV’s features IntroductionFeatures of your new TV Remote controlExploring your new TV FrontSelecting a location for the TV Back of TVLeft back panel Right back panelConnecting a VCR Connecting a cable converter box or antennaFrom Cable Connecting a DVD player/satellite receiver and a VCR DVD player with Component video For an Hdmi connection, see Connecting a camcorder To connect an Hdmi device, you will need Connecting an Hdmi or DVI deviceTo connect a DVI device, you will need Connecting an analog audio system To control the audioTV back panel You will need One pair of standard audio cablesYourTV To connect the IR blaster cablePower connection Connecting a PC personal computerMonitor display modes Using the remote control Preparing the remote control for useInstalling the remote control batteries Using the remote control to operate your other devicesProgramming the remote control to operate your other devices To control a DVD playerVCR DVD Remote control effective range Learning about the remote controlApprox ft meters Changing the on-screen display language Starting setupTo select a language Adding channels to the TV’s memory Programming channels automaticallyAdding and erasing channels manually Changing channelsPress Exit to return to normal ViewingRepeat steps 1-8 for the other ChannelsUsing the Locks menu Selecting a passwordTo select your password and access the Locks menu To change your passwordTo set up the video lock Locking channelsLocking the video inputs To unlock channelsSetting the GameTimerTM Using the panel lock featureLabeling channels To create channel labelsRepeat to enter the rest of the characters To erase channel labelsSetting the clock Selecting the video input sourceLabeling the video input sources To label the video input sourcesSetting the on timer Selecting the picture size Picture size, as described below and on the nextTheaterWide 2 picture size example TheaterWide 3 picture size exampleTo raise the picture, press Scrolling the TheaterWide picture TheaterWide 2 and 3 onlyTo lower the picture, press Selecting the cinema mode Using the Aspect featureTo set the Cinema Mode to Video off Aspect ratio of signal sourceTo turn off the Closed Caption feature Using the closed caption featureTo view captions or text Using the Long Life feature ReverseWhite Picture shiftSelecting the picture mode Adjusting the pictureAdjusting the picture quality Selecting the color temperature Using the CableClear featureResetting your picture adjustments Adjusting the sound Adjusting the sound qualityTo adjust the sound quality Muting the soundUsing the StableSound feature Resetting your audio adjustmentsTurning off the built-in speakers Using the SRS WOW surround sound feature To adjust the WOW featureSelecting the Hdmi audio input source To select the Hdmi audio input sourceDisplaying TV status information on-screen Picture/Audio adjustments in PC mode Resetting your picture/audio adjustments in PC modeTo reset your picture/audio adjustments WOW TruBassAuto power off Understanding the Power Return featureTroubleshooting Text mode30A0121AEnp45-bc 26/06, 626 PM Specifications Input 0.286V p-p burst signal, 75 ohm42HP86 50HP86 Input 1V p-p, 75 ohm, negative sync., Mini DIN 4 pin xLimited Canadian Warranty For Toshiba Brand Plasma Television Models from previous Service Centers