Toshiba 50A60 Height, Hit, Width, Vertical Linearity, Vlin, White Balance, Rcut, Gcut, Bcut, Rdrv

SPECIFIC INFORMATIONS GENERAL ADJUSTMENTS

ITEM		ADJUSTMENT PROCEDURE
HEIGHT	1.	Call up the adjustment mode display, then select the item HIT.
(HIT)	2.	Press the VOLUME s or t button to get the picture so the top of raster begins
		to lack.
	3. Press the VOLUME s button to advance the data by 10 steps.
	Note : Check the vertical picture position is correct.
WIDTH	1.	Call up the adjustment mode display, then select the item WID.
(WID)	2.	Press the VOLUME s or t button to get the picture so the left and right edges
		of raster begins to lack.
	3. Press the VOLUME s or t button to advance the data by 10 steps.
		Note : Check the horizontal picture position is correct.
VERTICAL LINEARITY	1.	Call up the adjustment mode display, then select the item VLIN.
(VLIN)	2.	Receive cross-hatch pattern signal.
	3. Press the VOLUME s or t
		button to obtain the picture of
		the best linearity.
	4. Then readjust the item HIT.
		Center
WHITE BALANCE	1.	Press RESET button on TV or remote hand set.
(RCUT)	2.	Call up the adjustment mode display, then adjust the data of items RCUT, GCUT
(GCUT)		and BCUT to “40”.
(BCUT)	3.	Press TV (ANT)/VIDEO button on TV.
(RDRV)	4.	Gradually rotate R, G and B SCREEN volume of FOCUS PAC (page 7) clock-
(BDRV)		wise or counterclockwise until the raster appears slightly on the CRT through
		the each lens, and leave them.
		(Look into the lens in order to check the raster.)
	5.	Press TV (ANT)/VIDEO button on TV again.
	6.	Exit from service mode.
	7.	Receive white laster pattern signal, and adjust the contrast to the minimum to
		make white picture to low light.
	8.	Adjust the data of items RCUT, GCUT and BCUT for low light area.
	9.	Adjust the contrast to the maximum to make white picture to high light.
	10.	Adjust the data of items GDRV and BDRV Controls for proper white-balanced
		picture in high light area.
	11.	Check the white balance in both low and high light areas. If necessary, perform
		again steps from 7 to 9.
	* The data of item GDRV changes red drive actually.

– 12 –