Toshiba 55LA8600, 60LA8600 YyGrounding, YyOutdoor Antenna Grounding, YyMoving, YyVentilation

Page 4

4IMPORTANT SAFETY INSTRUCTIONS

ENGLISH

yyGrounding

(Except for devices which are not grounded.) Ensure that you connect the earth ground wire to prevent possible electric shock (i.e. a TV with a three-prong grounded AC plug must be connected to a three-prong grounded AC outlet). If grounding methods are not possible, have a qualified electrician install a separate circuit breaker. Do not try to ground the unit by connecting it to telephone wires, lightening rods, or gas pipes.

Power Supply

Short-circuit

Breaker

yyAs long as this unit is connected to the AC wall outlet, it is not disconnected from the AC power source even if the unit is turned off.

yyDo not attempt to modify this product in any way without written authorization from LG Electronics. Unauthorized modification could void the user’s authority to operate this product.

yyOutdoor Antenna Grounding

(Can differ by country):

If an outdoor antenna is installed, follow the precautions below. An outdoor antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can come in contact with such power lines or circuits as death or serious injury can occur. Be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code (NEC) in the U.S.A. provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes and requirements for the grounding electrode.

Antenna grounding according to the National Electrical Code, ANSI/NFPA 70

yyCleaning

When cleaning, unplug the power cord and wipe gently with a soft cloth to prevent scratching. Do not spray water or other liquids directly on the TV as electric shock may occur. Do not clean with chemicals such as alcohol, thinners or benzine.

yyMoving

Make sure the product is turned off, unplugged and all cables have been removed. It may take 2 or more people to carry larger TVs. Do not press or put stress on the front panel of the TV.

yyVentilation

Install your TV where there is proper ventilation. Do not install in a confined space such as a bookcase. Do not cover the product with cloth or other materials while plugged. Do not install in excessively dusty places.

yyIf you smell smoke or other odors coming from the TV, unplug the power cord and contact an authorized service center.

yyKeep the product away from direct sunlight.

yyNever touch this apparatus or antenna during a thunder or lightning storm.

yyWhen mounting a TV on the wall, make sure not to install the TV by hanging the power and signal cables on the back of the TV.

yyDo not allow an impact shock or any objects to fall into the product, and do not drop anything onto the screen.

yyDisconnecting the Main Power

The power outlet used with this device must remain easily accessible.

yyStore the accessories (battery, etc.) in a safe location out of the reach of children.

yyThis apparatus use batteries. In your community there might be regulations that require you

to dispose of these batteries properly due to environmental considerations. Please contact your local authorities for disposal or recycling information.

yyDo not dispose of batteries in a fire.

yyDo not short circuit, disassemble or allow the batteries to overheat.

Ground Clamp

Electric Service Equipment

Ground Clamp

Antenna Lead in Wire

Antenna Discharge Unit

(NEC Section 810-20)

Grounding Conductor

(NEC Section 810-21)

Power Service Grounding

NEC: National Electrical Code Electrode System

(NEC Art 250, Part H)

Image 4
Contents LED TV Important Safety Instructions EnglishEnglish YyDisconnecting the Main Power YyGroundingYyOutdoor Antenna Grounding YyMovingPreventing Image burn or Burn-in on your TV ScreenYyDot Defect For USA and Canada YyGenerated SoundViewing 3D Imaging Viewing EnvironmentThose that have a photosensitive seizure or chronic illness Viewing AgeLicenses Open Source Software NoticeTable of Contents Unpacking Assembling and Preparing10 mm 0.39 inches *B 18 mm 0.7 inches Stand Screws Stand Base Tag OnOptional Extras AN-MR400 AG-FParts and Buttons Button DescriptionLifting and moving the TV Setting up the TV Attaching the standMounting on a table Leave a 10 cm 4 inch minimum space fromTidying cables Securing the TV to a wall optionalModel Mounting on a wallOptional Using Built-in Camera Preparing Built-in CameraName of Parts for the Built-In Camera Checking the Camera’s Shooting RangeConnecting to an antenna or cable Making ConnectionsConnecting to a HD receiver, DVD Player or VCR Hdmi ConnectionHdmi is the best way to connect a device ARC Audio Return ChannelDVI to Hdmi Connection Connecting to a mobile phone MHL Cable Not Provided Mobile phoneComponent Connection Composite Connection Hdmi Connection or DVI to Hdmi Connection Connecting a PCChoose method a or B to make connection Method B DVI to Hdmi Connection Connecting to an Audio System Digital Optical Audio ConnectionConnecting Headphones Connecting a USB DeviceMagic Remote Control Functions Voice recognitionRegistering Magic Remote Control How to use Magic Remote ControlPrecautions to Take when Using the Magic Remote Control How to register the Magic Remote ControlWatching TV Turning the TV on for the first timeUsing the User GUIdE Specifications ModelsHdmi DTV supported mode Component supported modeComponent port connecting information Hdmi PC supported mode3D supported mode HdmiPhoto 3D supported mode manuallyWiDi Maintenance TroubleshootingCleaning Your TV Power cordPage Child Safety Canada Register your product OnlineExternal Control Device Setup This feature is not available for all models Volume +Volume PowerExternal Control Device Setup USB TypeSerial port RS-232CSub Communication Parameters Space Ascii code ‘0x20’ Carriage Return Ascii code ‘0x0D’Set ID C8 Step 0F Step Volume Mute Command k e Aspect Ratio Command k c Main Picture SizeVolume Control Command k f Contrast Command k gTint Command k j ColorColour Temperature Command x uSharpness Command k k OSD Select Command k lColombia Model For South Korea, North/Latin America exceptFor Japan Model ChannelProgramme Add/DelSkip Command m b Control Back Light Command m gControl Panel Light Command m g For Plasma TV Input select Command x b Main Picture InputExtended 3DCommand x v only 3D models Depending on model DCommand x t only 3D models Depending on modelDon’t care