Toshiba TLP-X11E, TLP-X10Y, TLP-X20E Press VOL/ADJ +/ to set, No signal power off, Power on

FULL MENU settings – Default setting (continued)

CONTENTS 70

Remote control

Control panel

(Main unit side)

When selecting “No signal power off”, “Power on” or “Lamp power” in step 3.

4-c	Press VOL/ADJ (+/-) to set.
		No signal power off
		OFF:	The power does not turn off automatically even if the no
			signal status continues.
		5 min.:	The power turns off automatically if the no signal status
			continues for approx. 5 min.
		Power on

INPUTON/STANDBY

	LASER
KEYSTONE	AUTO	SET

L-CLICKR-CLICK

VOLUME/ADJUST

MENU ENTER EXIT

PIP FREEZE

RESIZE

CALL MUTE

4-c

5

AUTO AUTO

KEYSTONE SET

VOL/ADJ.

4-c

ENTER EXIT

5

MENU INPUT

ON/STANDBY

TEMP LAMP ON

BUSY FAN

Manual:	The power turns on by pressing the ON/STANDBY button.
Auto:	When the power cord is plugged, the power turns on.

Press the ON/STANDBY button when turns power off. 31

Lamp power

Hi:	Set the lamp mode with brightness priority.
Low:	Restrict the lamp output to reduce the cooling sound.

Note

The cooling sound changes according to the temperature inside the projector. When the lamp power setting is changed, the brightness changes immediately, but the cooling sound level does not change immediately.

5 EXIT After the settings are finished, press EXIT.

The menu screen disappears.

EXIT

Notes

•If the power is turned off by pressing the ON/STANDBY button, the adjustments or settings made are automatically stored in the memory. If the power cord is unplugged or if a power failure occurs while the projector is on, the adjustments or settings are not stored in the memory.

•The settings of “Default setting” are applied to all the input sources. (It is impossible to store different settings for each input source.)

Settings	Adjustments
	&