Using the Remote Control
Using the remote control
Preparing the remote control for use
The remote control will operate your TV, most VCR models, and most cable TV converters, even if they are different brands.
•The remote control is preprogrammed to operate most Toshiba VCRs and cable TV converters.
•If you own a
Installing the remote control batteries
To install the batteries:
1. Slide the battery cover off the back of the remote control.
2.Install two “AA” size batteries. Match the + and – symbols on the batteries to the symbols on the battery compartment.
Note:
The remote control provided with your TV may or may not operate certain features on your VCR, cable TV converter, or other electronic equipment. Refer to the owner’s manual provided with your other equipment to see which features are available. In addition, the other remote control may have buttons not available on your TV’s remote control. If you would like to use those features or buttons, you may need to use the original remote control provided with your other equipment.
Caution:
•Dispose of batteries in a designated disposal area. Do not throw batteries into a fire.
•Do not mix battery types or combine used batteries with new ones.
•Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment.
•If you do not intend to use the remote control for a long time, remove the batteries.
RECALL MUTE
o
POWER
3.Slide the battery cover back onto the remote control until the lock snaps.
Using the remote control to operate a VCR or cable TV converter
To control a VCR:
Set the TV/CABLE/VCR switch to the VCR position. The shaded buttons in the illustration at right will then control the VCR. The unshaded buttons will operate the TV as usual.
To control a cable TV converter:
Set the TV/CABLE/VCR switch to the CABLE position. The shaded buttons in the top portion of the illustration at right will then control the cable TV converter.
1 2 3
4 5 6
7 8 9
CH RTN
100 0 ENT
| CH |
| |
VOL | MENU/ | VOL | |
ENTER | |||
|
|
CH
TV
CABLE
VCR EXIT
FAV CH TV/VIDEO
A
REC TV/VCR STOP PLAY
STILL SOURCE PIP
SLOW PAUSE REW FF
PIP CH LOCATE SWAP
CHANNEL
NUMBERS
ENT (Used for the “Enter” command with some VCRs and cable TV converters
CHANNEL y z
TV/CABLE/VCR switch
VCR buttons (set
TV/CABLE/VCR switch to “VCR”)
12