Toshiba DVR620KC owner manual Hints for Timer Recording, Priority of Overlapped Settings

Page 42

TIMER RECORDING

Hints for Timer Recording

If there is a power failure or this unit has been unplugged for more than 30 seconds, the clock setting and all timer programming will be lost.

If a disc is not inserted or if a inserted disc is not recordable (finalized DVD-RW/-R, finalized DVD+RW, a fully recorded disc, etc.), “DVD” on the front panel

display flashes and timer recording cannot be performed. In some cases, will appear momentarily around the start point as the unit attempts to record. Please insert a recordable disc.

If a cassette tape with an erase-protection tab is not in the cassette compartment or there is no cassette tape in the cassette compartment, “VCR” on the front panel display flashes and timer recording cannot be performed. Please insert a recordable cassette tape.

If you press [TIMER SET] and turn on the unit while either DVD or VCR is in timer standby mode, disappears. In this case, you cannot change the mode between DVD and VCR. You cannot change any settings using [SETUP] or edit discs.

When all the timer recording is completed, flashes. To play back or eject the recorded disc, press

[I/ y ON/STANDBY] first, then select the recorded title and press [PLAY B], or [OPEN/CLOSE A] to remove the disc.

During timer recording or timer standby mode ( will appear), any operations on the unit will not be available. To make these operations available, press [STOP C] to

stop the timer recording or [TIMER SET] to cancel timer standby mode ( will disappear).

To cancel the timer standby mode, press [TIMER SET].

When the starting and the ending time are the same, “Exceeds 12 hours” appears and the program setting will not be accepted.

When the programmed starting and ending time are earlier than the current time, the setting will not be accepted.

If the starting time is earlier and the ending time is later than the current time, the recording will start right after [TIMER SET] is pressed.

The timer recording cannot be performed in DVD and VCR at the same time. If you set 2 programming with the same channel and time in both devices, the program with a lower program number will be recorded.

“Press TIMER SET for timer recording” will appear on the TV screen 5 minutes before the programmed starting time.

The Priority of Overlapped Settings

This unit records the programs according to priority if the timer programmings are overlapped. The timer programming set previously has priority.

A timer recording of lower priority will be canceled or start from the middle. Check the overlapped timer programmings and change the priority if necessary.

When the starting time is the same:

A program set previously (PROG. A) has priority.

When the starting time and the ending time for each programs are different:

A program that has earlier start time has priority.

PROG. A

 

 

PROG. B

 

 

actual

PROG. A A

PROG. B

recording

 

 

The first 2 minutes (at the longest) will be cut off.

PROG. A

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PROG. B

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

actual

 

 

 

 

 

 

 

 

PROG.B

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

recording

 

PROG. A

 

 

 

PROG. C

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The first 2 minutes (at the longest) will be cut off.

When the recording time is partially overlapped:

PROG. A will start after PROG. B is complete to be recorded.

PROG. A

PROG. B

 

 

 

 

 

 

 

actual

 

 

 

 

 

 

 

 

PROG. B

 

 

 

PROG. A

 

recording

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The first 2 minutes (at the longest) will be cut off.

When the recording time is entirely overlapped:

PROG.A will not be recorded.

PROG. A

 

PROG. B

 

actual

PROG. B

recording

 

Note for DVD recording

When the recording time of 2 programs are overlapped, or the end time of a program and the start time of another program is the same, the first 2 minutes (at the longest) of the subsequent program will be cut off.

If the cut-off portion comes up to 3 minutes or more, this program will be displayed with errors number E40 in the timer programming list.

When the end time of the programming currently being recorded and the start time of the subsequent program are same:

The beginning of the PROG. B may be cut off.

PROG. A

PROG. B

 

 

 

 

 

 

 

actual

 

 

 

 

 

 

 

 

PROG. A

 

 

 

PROG. B

 

recording

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The first 2 minutes (at the longest) will be cut off.

42EN

Image 42
Contents Disc Introduction Connections Basic Setup Management Owner’sPrecautions Symbol for Class ll Double InsulationAdditional Safety Instructions To Avoid the Hazards of Electrical Shock and Fire PrecautionsAvoid a place with drastic temperature changes Location and HandlingAvoid the Hazards of Electrical Shock and Fire Installation LocationSupplied Accessories About CopyrightCleaning Discs Maintenance ServicingCleaning the Cabinet Cleaning the Disc Lens Disc HandlingContents Contents Features Features Unplayable Discs Color SystemsRegion Codes Functional Overview Front PanelRear Panel Open the cover Insert batteries Remote ControlFunctional Overview Close the coverSetup button OPEN/CLOSE a button DVD modeVCR mode Clear button DVD modePress DVD on the remote control Verify that the DVD indicator is litFile Name Information On-Screen Display / MenuDisc Information/Menu Title Name Information MP3/WMA Tag InformationTitle name information VCR modeGuide to ON-SCREEN Displays and Menus File name informationMain Menu Front Panel Display Guide Display MessageConnections Connecting to an External TunerWith this setup TV Connection OverviewConnections Connecting to a TV Using an Hdmi Compatible PortHdmi Video Resolution and Actual Output Signals No supplied cables are used in this connectionConnecting to a TV Using Component Video Input Jacks Connecting to a TV Using an S-Video Input JackRCA audio cable L/R x RCA video cable x Connecting to a TV Using Audio / Video Input JacksConnecting to a TV without Audio / Video Input Jacks Set channel 3 orNo supplied cables are used in these connections To set up Hdmi Audio, refer to pages 84Digital Audio Connection Coaxial Cable ConnectionChannel Analog Audio Connection RCA audio cable L/R xInitial Setting Proceed to in Setting Clock onSetting the Clock Settings for the Video Input Formatting a Disc Choosing the Recording Format of a Brand-New DVD-RWFormatting a Disc VR mode DVD-RWIf you want to cancel formatting, select No Reformatting a Disc ManuallyUse K / L to select Disc Protect Setting a Disc to ProtectTo cancel the disc protect OFF ON, then press EnterUse K / L to select Recording End of Timer Rec, then pressAuto Finalizing Use K / L to select Disc Full orFinalizing a Disc Press Setup Use K / L to select DVD Menu, then press EnterPlaying the Discs in Other DVD Players Finalizing is completedTo cancel finalizing DVD-RW only Restrictions on Recording Recording ModeInformation on DVD Recording VideoPress Setup to exit Settings for a RecordingSetting for Auto Chapter Make Recording CompatibleRecording Audio Select XP Settings for a RecordingSetting Aspect Ratio for Video Mode RecordingPress OPEN/CLOSE a to close Press REC Mode repeatedly to Select a recording modePress DVD PressPress REC I to start recording Press Stop C to stop recordingWill be displayed for 5 seconds Timer Recording Press Timer ProgUse K / L to select New Program Timer Recording To stop the timer recording in progress When the starting time is the same Hints for Timer RecordingPriority of Overlapped Settings When the recording time is partially overlappedSelect whichever the component Select the desired recording modeSatellite Link Press SAT. LinkExternal device Settings for AN External DeviceConnection to an External Device Camcorder, VCR etcSettings for AN External Device Recording from an External DeviceDV Dubbing Guide to DV and On-Screen DisplayDV Dubbing DVC to DVD DubbingRepeat the steps 1 and 2 on DVC to VCR DubbingPress VCR first To stop recording, press Stop CUse K / L to select Recording, then press Enter DVD/VCR DubbingUse K / L to select Dubbing Mode, then press Enter Make sureUse K / L to select DVD VCR DVD/VCR DubbingUse K / L to select VCR DVD, then press Enter Press Stop C to stop the recordingStructure of Disc Contents Information on PlaybackPress I/ y ON/STANDBY Basic PlaybackDirect Playback Press Play B to start playbackBasic Playback Playback from the Title ListDisc tray Follow steps 1 to 2 in DirectPlayback on Or track/file, then press EnterUsing the Title/Disc Menu PauseSpecial Playback Resume PlaybackFast Forward / Fast Reverse Playback Step by Step Playback Special PlaybackRapid Playback Slow Forward / Slow Reverse PlaybackPress DVD first During playback, press Display or Zoom Marker SettingZoom Use / B to select menuWhile viewing a TV broadcast via this unit, press Time Slip Chasing Playback during RecordingDuring recording, press Play B Press Time Slip againChapter Simultaneous Playback and RecordingSelected title playback will start To move to for chapter, press BSearch Using Skip j / SkipUsing Display Title/Chapter SearchSearch Time SearchAudio CD Repeat Playback Random PlaybackProgram Playback 5Press Play BCan switch them during playback Switching SubtitlesSwitching Audio Soundtrack Lleft or Rright Press DVD firstSwitching Virtual Surround System Switching Camera AnglesSelecting the Format of Audio and Video Adjusting Black Level Reducing Block NoiseInformation on Disc Editing Guide to a Title ListEditing Discs Full-Recorded disc Deleting TitlesAfter the disc is fully recorded New titleUse K / L to select Title Delete, then press Enter You delete the title Switch between Original and PlaylistDeleting Titles Press Return or Stop C to exitCREATING/DELETING Playlist Adding Titles to a PlaylistUse K / L to select Delete All CREATING/DELETING PlaylistErasing All Playlist PlaylistsEditing Discs Putting Names on TitlesEditing Discs Guide to Edit Title NamePress Return Setting Chapter MarksUse Skip H / G Press Return again and thenUse K / L to select Edit, then press Enter Hiding ChaptersPress DVD Stop mode, press TOP Menu Use K / L to select Hide Chapter, then press EnterEdit menu Deleting a Part of a TitleFollow the steps 1 to 3 in Putting Use K / L to select Scene DeleteThen press Enter Use K / L to select Delete thenUse K / L to select Yes then press Part of the title is deletedFor VR mode DVD-RW Proceed to step For VR mode DVD-RW, press Disc Menu to select PlaylistVR mode DVD-RW playlist Dividing a TitleCombining Titles Use K / L to select Title Combining, then press EnterTwo titles will combine into a single title Setting or Releasing the Title Protection Refer to Setting a Disc to Protect onInterval, then press Enter Setting or Clearing All Chapter Marks at OnceUse K / L to select the desired Press Return and then Return or Stop C to exitList of the Default Settings List of the Default Settings Use K / L to select Playback, then press Enter General SettingPlayback Use K / L to select a desired item, then press EnterUse the Number buttons to enter the current password General SettingParental Lock Default OFF Your setting will be activatedAudio Out Subtitle Language Default OFF Disc Menu Language Default EnglishAudio Language Default Original Angle Icon Default onFL Dimmer Default Bright OSD Language Default EnglishScreen Saver Default 10 minutes DisplayTV Aspect Default 169 Wide When you finish with the setting Press Setup to exitProgressive Default OFF VideoSet to OFF when the Hdmi sound is not output Format Default RGBHdmi Audio Default on RGB Range Default NormalReset All To select General SettingInformation on VCR Functions Setup VCR Function OthersVCR Functions Recording speedUsing REC I or Stop C One-touch Timer Recording OTRYou cannot pause the one-touch timer recording VCR FunctionsOther Operations Troubleshooting Symptom RemedyTroubleshooting SymptomHdmi sound is not output when Hdmi Audio is set to OFF Frequently Asked Questions Can I record to CD-RW/-R? No, this unit records only DVDOn pages 19, 27 and 39 Language Code Language CodeGlossary Recording SpecificationsGeneral Input / OutputLimited Warranty LPLWHG2QH  HDUDUUDQW\RQ3DUWVDQG/DERXULimited Warranty $UELWUDWLRQDQGLVSXWH5HVROXWLRQMemo Others1VMN31873 / E9PKCCD