Toshiba DVR620KU owner manual Troubleshooting, Symptom

TROUBLESHOOTING

Symptom

DV signal cannot be input.

Remedy

•Before connection, turn on the power supplies for both this unit and the DVC, and make sure that these units are in stop mode.

•Only a “DVC-SD” signal can be input from the DVC to this unit. Other types of signals are not supported.

•Do not connect any device other than the DVC. Even if a recorder or PC with another DV terminal is connected, the DV function will not operate.

•If the DVC is not recognized after connection, turn off the power supply for the unit and re-connect the DVC.

D V D

•

V C R

The DVC cannot be operated with this	• Signal input or DVC operation from this unit may be disabled
unit.	depending on the type of DVC.
	• If a DVC signal cannot be input, use an external input (L1 (Rear)/L2
	(front)) for analog connection via audio/video cables.
	• DVC control may be disabled depending on the type of DVC, even in a
	mode other than camera mode. In this case, switch to DVD control and
	execute the normal recording procedure while operating the DVC.
Certain functions of the unit cannot	• Some functions may not operate depending on the type of DVC. For
operate.	example, if the DVC does not support slow playback mode, the slow
	playback function is disabled.
	• With L3 (DV-IN), the disc display menu does not appear unless disc
	playback is executed.
DV audio signal cannot be switched.	• For recording with the DVC, the recording audio signal can be set to 12
	bits or 16 bits. However, when 16-bit recording mode is selected, audio
	signal cannot be switched. To record an audio signal, set it to 12 bits.

No image from HDMI connection.

•Check the HDMI connection. (Check the status of the HDMI related indications.)

•Check whether the connected monitor device or other device supports HDCP. (This unit will not output a video signal unless the other device supports HDCP.)

•Check the setting of HDMI.

•Check whether the output format of this unit (HDMI FORMAT) matches the supported input format of other connected device.

•If the unit is connected to the unauthorized display device with an HDMI cable, the audio/video signal may not be output when playing back a commercial DVD-video.

	There is no picture.	• If the setup menu appears on the TV screen, press [RETURN] to exit.
		• Check if the progressive scan mode is set correctly according to your TV
		(page 95).
	Picture noise appears.	• Clean the disc with a cleaning cloth.
	Playback picture from the external	• If the picture output signal from the external devices passes through this
	devices connected to this unit is	unit to get to your TV, the copy protection signal applied to some DVD could
	distorted.	affect the picture quality. Disconnect the playback device in question and
		connect it directly to your TV.
	There is no sound.	• If you are using DIGITAL AUDIO OUTPUT (COAXIAL) jack, check the setting
		in “Audio Out” (page 90).
		• Clean the disc with a cleaning cloth.
D	Sound is noisy.	• Clean the disc with a cleaning cloth.
V	The disc does not play back.	• No disc is inserted.
D		• A blank disc is inserted.
		• The disc is upside down. Insert the disc with the labeled side facing up.
		• The disc is not correctly inserted.
		• The unit cannot play back certain discs (such as a CD-ROM) (page 10).
		• The region code on the DVD-video does not match the unit (page 10).
		• Moisture has condensed inside the unit. Remove the disc and leave the
		unit turned on for about 2 hours until the moisture evaporates (page 4).
		• If the disc was recorded on another recorder, the unit cannot play back
		the disc if it was not finalized.
	Playback image freezes for a second.	• During the playback of 2 layered disc, picture may freeze for a moment
		when the 1st layer switches to the 2nd layer. This is not a malfunction.

Discs recorded on this unit cannot be played back on other DVD players.

•If you are using DVD-RW/-R or DVD+R, please ensure you finalized the disc after recording (pages 31-33).

104 EN

E9PKAUD_DVR620KU_EN.indd 104

3/25/2009 3:49:11 PM