Toshiba D-R420KU owner manual Precautions, To Avoid the Hazards of Electrical Shock and Fire

Page 3

PRECAUTIONS

FCC WARNING

This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

RADIO-TV INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Disconnect the mains plug to shut off when find trouble or not in use. The mains plug shall remain readily operable.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

WARNING: Batteries (Battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

LASER SAFETY

This apparatus employs a laser. Only a qualified service person should remove the cover or attempt to service this apparatus, due to possible eye injury.

CAUTION: Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

CAUTION: Visible and invisible laser radiation when open and interlock defeated. Do not stare into beam.

LOCATION: Inside, near the deck mechanism.

IMPORTANT COPYRIGHT INFORMATION

Unauthorized copying, broadcasting, public performance and lending of discs are prohibited. This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.

Do not place the unit on the furniture that is capable of being tilted by a child and an adult leaning, pulling, standing or climbing on it. A falling unit can cause serious injury or even death.

To Avoid the Hazards of Electrical Shock and Fire

•Do not handle the power cord with wet hands.

•Do not pull on the power cord when disconnecting it from an AC outlet. Grasp it by the plug.

•Do not put your fingers or objects into the unit.

Location and Handling

•Do not install the unit in direct sunlight, near strong magnetic fields, or in a place subject to dust or strong vibration.

•Avoid a place with drastic temperature changes.

•Install the unit in a horizontal and stable position. Do not place anything directly on top or bottom of the unit. Depending on your external devices, noise or disturbance of the picture and/or sound may be generated if the unit is placed too close to them. In this case, please ensure enough space between the external devices and the unit.

•Depending on the environment, the temperature of this unit may increase slightly. This is not a malfunction.

•Be sure to remove the disc and unplug the AC power cord from the outlet before carrying the unit.

Disc

Introduction Connections Basic Setup Management Recording Playback Editing Function Setup Others

EN 3

E7PCAUD_DR420KU_EN.indd 3

2/6/2009 10:55:21 AM

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Editing Owner’s RecordPrecautions Symbol for Class ll Double InsulationAdditional Safety Instructions Precautions To Avoid the Hazards of Electrical Shock and FireLocation and Handling Avoid the Hazards of Electrical Shock and Fire Installation LocationSupplied Accessories Dew Condensation WarningCleaning the Disc Lens Disc Handling Maintenance ServicingCleaning the Cabinet Cleaning DiscsContents Contents Editing FeaturesRecording Compatibility PlaybackDVD-RW DVD+RW FeaturesCD-DA CD-RW Unplayable DiscsColor Systems Region CodesRear Panel Disc Basic Setup Management Recording PlaybackFunctional Overview Front PanelOpen the cover Insert batteries Installing the Batteries in the Remote ControlUsing a Remote Control Functional OverviewIntroduction Connections Basic Setup OFF On-Screen Display / MenuFile name information Connections Basic SetupGuide to ON-SCREEN Displays and Menus Title name information IntroductionMain Menu Display Message Disc Basic Setup Management RecordingPlayback Editing Function Setup Others Front Panel Display GuideSupplied cables used in this connection are as follows Connecting to an External TunerConnections TV Connection OverviewNo supplied cables are used in this connection Connecting to a TV with an Hdmitm Compatible PortHdmi Video Resolution and Actual Output Signals ConnectionsConnecting to a TV with an S-Video Input Jack Connecting to a TV with Component Video Input jacksPlayback Editing Connecting to a TV with Audio / Video Input JacksConnecting to a TV without Audio / Video Input Jacks Function Setup OthersNo supplied cables are used in these connections To set up Hdmi Audio, refer to pages 82To set up Dolby Digital, refer to pages 81 Digital Audio ConnectionPlayback Channel Analog Audio ConnectionLanguage Initial SettingProceed to in Clock Setting on Use K / L to select your desiredEditing Function Setup Others Setting the ClockClock Setting Press Setup to exitIn, then press Enter Settings for the Video InputUse K / L to select Format Mode, then press Enter Formatting a DiscChoosing the Recording Format of a Brand-New DVD-RW Use K / L to select Format, then press EnterFormatting is completed.100% is indicated If you want to cancel formatting, select NoFormatting a Disc Reformatting a Disc ManuallyUse K / L to select Yes, then press Enter Setting a Disc to ProtectPress Setup Use K / L to select DVD Menu, then press Enter Use K / L to select Disc ProtectEnter Press Setup and use K / L toSelect General Setting, then press Auto FinalizingPlaying the Discs in Other DVD Players Finalizing a DiscFinalizing is completed 32 EN Video Recording ModeInformation on DVD Recording Restrictions on RecordingMake Recording Compatible Settings for a RecordingSetting for Auto Chapter Press Setup to exitRecording Settings for a RecordingSetting Aspect Ratio for Video Mode Recording Audio Select XPIt may take awhile to load Disc completely Press OPEN/CLOSE a to close the disc trayFollow the steps to record TV programs Align the disc to the disc tray guideWill be displayed for 5 seconds Disc Connections Basic Setup Management RecordingPress REC I to start recording Press Stop C to stop recordingIf you have not set the clock yet Timer RecordingGuide to Timer Programming Display Before recording, make surePress I/yON/STANDBY to set a timer programming Timer RecordingUse K / L to select a recording mode Press Enter when all items are enteredTo stop the timer recording in progress Editing Function Hints for Timer RecordingPriority of Overlapped Settings Disc Connections Basic Setup ManagementSatellite Link Preparation on this unitPress Stop C Satellite Link Connection to an External Device External deviceIt takes awhile to load Disc Settings for AN External DeviceRecording from an External Device Press OPEN/CLOSE a again to close the disc trayGuide to DV and On-Screen Display Recording audio modeIndicator of dubbing function DV DubbingUse Input Select to select L3 DV-IN Press REC Mode repeatedly to Select a recording modeDV Dubbing DVC to DVD Dubbing48 EN Information on Playback Structure of Disc ContentsPress Stop C once to stop playback temporarily Basic PlaybackDirect Playback Press I/y ON/STANDBYStart, then press Enter Basic PlaybackPlayback from the Title List Use K / L to select Play FromJpeg Playing Back an Audio CD and a CD-RW/-R with MP3/JPEG FilesUsing the Title/Disc Menu Playback will be paused and sound will be muted2Press Play B to return to the normal playback Fast Forward / Fast Reverse Playback Special PlaybackResume Playback Skipping TV Commercials During PlaybackSlow Forward / Slow Reverse Playback Special PlaybackRapid Playback Step by Step PlaybackUse / B to select to display the selection menu Marker SettingZoom During playback, press Display or ZoomThis unit start to record the TV broadcast Chasing Playback during RecordingDuring recording, press Play B While viewing a TV broadcast via this unit, press Time SlipTo move to for chapter, press B Simultaneous Playback and RecordingSelected title playback will start ChapterTitle/Chapter Search Using Skip j / SkipUsing Display SearchSearch Time SearchAudio CD Random Playback Repeat Playback5Press Play B REPEAT/RANDOM/PROGRAM PLAYBACK/SLIDE ShowProgram Playback Slide ShowIf you press Audio , skip to Switching SubtitlesSwitching Audio Soundtrack TOP Menu to display the disc menuSwitching Virtual Surround System Switching Camera Angles Selecting the Format of Audio and VideoReducing Block Noise Use K / L to select OFF or ON, then press Enter Adjusting Black LevelYour setting will be activated Use K / L to select Black Level, then press EnterGuide to a Title List Information on Disc EditingRecording Playback Disc Basic Setup ManagementDeleting Titles After the disc is fully recordedTitle list, original or playlist will appear Switch between Original and PlaylistDeleting Titles Use K / L to select Title Delete, then press EnterUse K / L to select Add To Playlist, then press Enter Disc Connections Basic Setup Management Recording PlaybackCREATING/DELETING Playlist Adding Titles to a PlaylistErasing All Playlist CREATING/DELETING PlaylistPutting Names on Titles Editing DiscsEditing Discs Putting Names on Titles cont’dGuide to Edit Title Name Press Return again and then Return or Stop C to exit Setting Chapter MarksUse Skip H / G Press ReturnPress Enter Hiding ChaptersUse K / L to select Edit, then Use Skip H or Skip G to decide the chapter to be hiddenVR mode DVD-RW playlist Deleting a Part of a TitleInstructions continue on the next Deleting a Part of a Title cont’d Use K / L to select Delete then press EnterPress Return and then Return or Stop C to exit Use K / L/s / B to select a desired title, then press Enter For VR mode DVD-RW, press MENU/LIST to select PlaylistFor VR mode DVD-RW Proceed to step Dividing a TitleCombining Titles You can combine two titles into a single titleTwo titles will combine into a single title Use K / L to select Protect, then Setting or Releasing the Title ProtectionTo protect a whole disc VR mode DVD-RW, DVD+RW/+R only Confirm the indication OFF ON. Press Enter againUse K / L to select the desired interval, then press Enter Setting or Clearing All Chapter Marks at OnceThen press Enter Use K / L to select Chapter MarkSetup Items highlight is the default Contents List of the Default SettingsItems highlight is the default Contents List of the Default SettingsThen press Enter General SettingPlayback Use K / L to select a desired itemPlayback cont’d General SettingParental Lock Default OFF Use the Number buttons to enter the current passwordAudio Out Angle Icon Default on Disc Menu Language Default EnglishAudio Language Default Original Subtitle Language Default OFFDisplay OSD Language Default EnglishScreen Saver Default 10 minutes FL Dimmer Default BrightChip Display cont’dCanadian French Rating Use the Number Buttons to enter new access passwordSelected item Progressive Default OFFTV Aspect Default 169 Wide VideoFormat Default RGB Hdmi cont’d Hdmi Audio Default onRGB Range Default Normal Hdmi CEC Default OFFEditing Function Setup Others Reset AllSelect Yes using K / L , then press Enter Reset the setting to defaultPicture TroubleshootingPower Remote controlTroubleshooting Recording / Timer recording / EditingStop C Hdmi RemedyCan I record to CD-RW/-R? Frequently Asked QuestionsLanguage Code Language CodeGlossary Input / Output SpecificationsGeneral RecordingLimited Warranty Limited WarrantyLPLWHG2QH  HDUDUUDQW\RQ3DUWVDQG/DERXU Limited Warranty$UELWUDWLRQDQGLVSXWH5HVROXWLRQ
Top Page Image Contents