Rear Panel

Pioneer DV-525 operating instructions Rear Panel

3 4 5 6

					COMPONENT
					VIDEO OUT
					Y		AC IN
DIGITAL OUT
OPT.	TV SYSTEM		VIDEO OUT	S-VIDEO OUT	PB	AUDIO OUT
CONTROL	TV SYSTEM		VIDEO			R	L
IN			OUT			R	L
IN		PAL	SELECT
	NTSC	AUTO
					PR

(The TV SYSTEM switch and AC IN power cord connection terminal are not present on U.S. and Canadian models)

1DIGITAL OUT jacks (coaxial, optical (OPT.)) Use to output the digital audio signal recorded on discs. You can output the digital signal via either coaxial or optical output jack to an AV amplifier or receiver (page 16).

2CONTROL IN jack

Use to connect this player to another component bearing the Pioneer ë mark. This lets you control this unit as though it were a component in a system. Player operations are then performed by pointing the remote control at the component that the player is connect to (page 18).

3TV SYSTEM switch

Use to change the TV signal mode to either PAL or NTSC according to the type of TV and disc to be used. When the switch is in the AUTO position, the player outputs the format on the disc as is (page 18). (The TV SYSTEM switch is not present on U.S. and Canadian models.)

4VIDEO OUT SELECT switch

Use to set which output is used to output the video signals. Select either video/S-video or component video signal output depending on the connections you make (page 17).

5VIDEO OUT jack

Connect to the video input on a TV or monitor or AV amplifier or receiver with video input capability. When using this output, be sure to set VIDEO OUT SELECT to the left position (pages 15 and 17).

6S-VIDEO OUT jack

If your TV or monitor has an S-video input, clear picture reproduction is possible by connecting the player to your TV or monitor via the S-Video jack. When using this output, be sure to set VIDEO OUT SELECT to the left position (page 17).

7COMPONENT VIDEO OUT jacks

If your projection monitor, projector or similar component has component video inputs, you can produce a higher quality picture on your projection monitor or projector by connecting to the component video outputs on this unit. When using these jacks, be sure to set VIDEO OUT SELECT to the right position (page 17).

8AUDIO OUT jacks

Use to output two-channel audio (analog) to the audio stereo inputs on a TV or stereo amplifier. If you are connecting to a receiver that has both digital and analog input jacks for DVD player connection, it may be beneficial to make both connections (pages 15 and 16).

9AC IN power cord connection terminal Use to connect the power cord to the wall outlet (page 15). (The AC power cord of the U.S. and Canadian models is built into the player.)