Pioneer DV-333 operating instructions Rear Panel

Rear Panel

1			2	3 4	5	6
COMPONENT VIDEO OUT			DIGITAL OUT			AC IN
Y	PB	PR		DIGITAL
				OUT
				OPT
				VIDEO	CONTROL
				OUT	IN
				SELECT
R	L	VIDEO	S-VIDEO
AUDIO OUT
		OUT	OUT

9 8 7

NAMES AND FUNCTIONS

1COMPONENT VIDEO OUT jacks

If your TV or monitor has component video inputs, you can produce a higher quality picture on your TV or monitor by connecting to the component video outputs on this unit. When using these jacks, be sure to set VIDEO OUT SELECT to the right position (page 16).

2DIGITAL OUT jack (coaxial)

Use to output the digital audio signal recorded on discs. You can output the digital signal via either coaxial output jack to an AV amplifier or receiver (page 15).

3VIDEO OUT SELECT switch

Use to set which output is used to output the video signals. Select either video/S-video or component video signal output depending on the connections you make (page 16).

4DIGITAL OUT jack (optical (OPT.))

Use to output the digital audio signal recorded on discs. You can output the digital signal via either optical output jack to an AV amplifier or receiver (page 15).

6AC IN power cord connection terminal Use to connect the power cord to the wall outlet (page 14).

7S-VIDEO OUT jack

If your TV or monitor has an S-video input, clear picture reproduction is possible by connecting the player to your TV or monitor via the S-Video jack. When using this output, be sure to set VIDEO OUT SELECT to the left position (page 16).

8VIDEO OUT jack

Connect to the video input on a TV or monitor or AV amplifier or receiver with video input capability. When using this output, be sure to set VIDEO OUT SELECT to the left position (pages 14, 16).

9AUDIO OUT jacks

Use to output two-channel audio (analog) to the audio stereo inputs on a TV or stereo amplifier. If you are connecting to a receiver that has both digital and analog input jacks for DVD player connection, it may be beneficial to make both connections (pages 14, 15).

5CONTROL IN jack

Use to connect this player to another component bearing the Pioneer ë mark. This lets you control this unit as though it were a component in a system. Player operations are then performed by pointing the remote control at the component that the player is connect to (page 16).

11