Toshiba SD-V593SU owner manual Output, Interlace, Progressive

Output

You can select the video output signal of the DVD video player to the TV from “Interlace” or “Progressive”.

1)Press C or D to select “Output”.

2)Press A, then press C or D to select “Interlace” or “Progressive”.

Interlace:

Select when connecting to a composite TV or a TV equipped with component video inputs but progressive scan is not compatible.

Progressive:

Select when connecting to a TV equipped with component video inputs, progressive scan compatible.

3)Press ENTER.

Warning:

Once “Progressive” is selected when connecting to a TV progressive scan incompatible, no image will be seen on the video display.

In this case, you must reset the unit by pressing STOP on the front panel for five seconds. The video output will be restored to “Interlace” setting, and a picture will once again be seen on a conventional analog display.

Notes:

•Some discs may not be played back with the progressive scanning mode correctly because of the disc characteris- tics or recording condition.

•Once Progressive scan on, the VIDEO (yellow) and S- VIDEO outputs are disabled.

Note:

If each setup (pages 60~63) has been completed, the unit can always be worked under the same conditions (especially with DVD discs).

Each setup will be retained in the memory even if you turn the power off.

Function setup (DVD)

63

2F90201A (E)p59-63 63 4/4/05, 9:03 PM