Bose AM259777 manual Connecting the antennas, Connecting an FM antenna, Connecting the AM antenna

Page 14

System Installation Instructions

Connecting the antennas

The rear panel of the media center provides connections for AM and FM antennas (Figure 11). Be sure to unwrap the bundled antenna wires and straighten them as much as possible to ensure the best reception.

Note: Outdoor antennas may be used. To install an outdoor antenna, consult a qualified installer. Follow all safety instructions supplied with the antenna.

Figure 11

Connections for the AM and FM antennas

AM antenna

FM dipole

lead

antenna lead

 

33V

DC POWER

 

TV

1.1A

 

 

SENSOR

 

 

 

 

 

AM

 

 

 

FM

75

RECORD TAPE AUX VCR TV

VIDEO INPUTS

L

L

L

L

L

COMPOSITE S-VIDEO

IR

ANTENNA

 

 

 

 

 

EMITTER

 

 

 

 

 

1

OPTICAL

OPTICAL

R

R

R

R

R

 

 

 

 

 

SERIAL

 

 

 

 

 

 

 

DATA

 

 

 

 

 

 

 

2

INPUT

OUTPUT

DIGITAL

DIGITAL

DIGITAL

DIGITAL

DIGITAL

SPEAKER

 

 

 

 

COMPOSITE S-VIDEO

ZONES

 

AUDIO OUTPUTS

 

AUDIO INPUTS

VIDEO OUTPUTS

Connecting an FM antenna

Plug the connector on the FM dipole antenna lead into the FM antenna jack. Spread out the antenna arms. Change the orientation of the antenna arms to get optimum FM reception. Place the antenna as far from the media center and other components as possible.

Connecting the AM antenna

Note: To mount the AM antenna on a wall, follow the instructions enclosed with the antenna.

1.Plug the connector on the AM antenna lead into the AM antenna jack.

2.Stand the loop antenna on the base, following the instructions enclosed with the AM antenna.

3.Move the AM loop antenna as far as possible, at least 20 inches (50 cm), from the media center, and at least 2 feet (60 cm) from the Acoustimass® module. Experiment with the orientation of the loop for optimum AM reception.

Connecting to a cable radio provider

Some cable TV providers make FM radio signals available through the cable service to your home. This connection is made to the external FM jack on the back panel of the media center. To connect to this service, contact your cable TV provider for assistance.

Note: Make sure that the cable radio installation includes a signal splitter so that only the FM radio band, not the cable TV band, is received by the media center. If necessary, contact a qualified installer.

14

AM259777_02_V.pdf • April 23, 2002

Image 14
Contents Installation Guide Lifestyle DVD Home Entertainment SystemsSafety Information For your recordsContents Welcome Symbols used in this guideIntroduction Region numbersGetting started System InstallationSystem connection diagram Cables and accessories Included with your system System Installation InstructionsCables and accessories Recommended speaker locations Left and right front speaker placementPlacing your speakers Speaker placement and reflection rays Center speaker placementSurround speaker placement LeftAcoustimass module placement Right and wrong place- ments for the Acoustimass moduleFront door Make sure you have Front features of mediaPlacing your media center CenterTwo-wire connection type speaker Connecting the speakers to the Acoustimass moduleMaking a two-wire speaker connection Terminal tab Red + wireMaking a plug-in cable speaker connection Front speakers Surround speakers Left Center RightAudio input cable Connecting the Acoustimass module to the media centerAcoustimass module Connector panel Connecting the AM antenna Connecting the antennasConnecting an FM antenna Connecting to a cable radio providerMaking video connections Connecting your TV to the systemMaking audio connections Connecting your VCR to the system optional Component video adapter connectionsCable/satellite box Connecting your cable/satellite box to the system optionalBox connector Turning off the internal speakers in your TV Installing the TV on/off detector optionalTV on/off detector installed On your TVPower connection of the Acoustimass module Connecting the system to powerHeadset connection for use in the final setup steps Connector panel Power switchRemote control battery installation Installing the remote control batteriesPower connection of the media center To get started Finishing the installationContents of the small car- ton Save the headset for possible future use Reference Using alternate system connectionsDiagram of a typical system To play VCR audio not TV audio through your systemAUX left & right audio if available What do I need for setting up a second zone? Setting up a second listening zoneWhat is a zone? How do I set up a speaker system in a second zone?Media center connector panel Connecting external equipmentConnecting record/playback equipment Record/playback connec- tionsConnecting other playback equipment Using digital audio connectionsUsing optical digital audio connections AUX input connectionsWarranty Connecting the optional IR emitter cableAccessories Contacting customer serviceTechnical information Page