Important Safety Instructions

15. Outdoor Antenna Grounding

If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antennadischarge unit, connection to grounding electrodes, and requirements for the grounding electrode. See figure below.

Introduction

20. Servicing

Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

21. Damage Requiring Service

Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

A)When the power-supply cord or plug is damaged, B)If liquid has been spilled, or objects have fallen into the product,

Remote Control Preparation

Other

	Insert batteries		Using the remote control

1	1. Open the cover.	Point the remote control at the remote sensor.

(The pictures below are for reference only.)

DVD-6800

DVD/CD/CD-R/CD-RW/DVD-R/DVD-RW/HDCD/JPEG PLAYER

16. Lightning

For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power lines surges.

17. Power Lines

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

18. Overloading

Do not overload wall outlets, extension cords, or integral convenience receptacles, as this can result in a risk of fire or electric shock.

19. Object and Liquid Entry

Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.

C)If the product has been exposed to rain or water, D)If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician

to restore the product to its normal operation, E)If the product has been dropped or damaged in any way, and

F)When the product exhibits a distinct change in performance this indicates a need for service.

22. Replacement Parts

When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.

23. Safety Check

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

24. Wall or Ceiling Mounting

The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

25. Heat

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

2	2. Insert batteries.

Make sure to match the "+" and "-" of the batteries

with the marks inside the battery compartment.

3	3. Close the cover.

Notes:

Improper use of batteries may cause battery leakage and corrosion. To operate the remote control correctly,follow the instructions below: Do not insert the batteries in the wrong dir-

ection.

Do not charge, heat, open, or short-circuit the batteries.

Do not throw batteries into a fire.

Do not leave dead batteries in the Remote Control.

Do not use different types of batteries tog- ether, or mix old and new batteries.

If you do not use the remote control for a long period of time, remove the batteries to avoid possible damage from battery corrosion.

If the remote control does not function cor- rectly or the operating range becomes re- duced, replace all batteries with new ones. If battery leakage occurs, clean the battery compartment, then insert new ones.

30	o			o
30	o		30
			30
STANDBY			OPEN/CLOSE
		PROG	DISPLAY
N/P
		1	2	3
SUBTITLE
		4	5	6
AUDIO
		7	8	9
ANGLE
		0	10+	TIME
SETUP				REPEAT
KEY-		ENTER		KEY+
VOL-				VOL+
		STOP
ZOOM		VOCAL	MIC/ K Shift	RESUME
PBC		TITLE	A B	MENU
PREV		NEXT	REV
SLOW		PAUSE	PLAY

MUTE STEP RETUNE MODE

Remarks: Do not expose the remote sensor of the

DVD Player to a strong light source, such as direct

sunlight.

Notes:

Point the remote control directly at the player's remote sensor.

Do not leave the remote control in an extremely hot or humid place.

Do not spill water or put anything wet on the remote control.

Battery life is ~1 year under normal conditions.