TAG DVD32FIR manual Main functions, Playing a DVD CD, Inserting a disc Front display brightness

20 main functions

After the setup is completed

...let’s go through the player’s controls

playing a DVD (CD) 21

inserting a disc

front display brightness

Pressing display will cycle through the display brightness options. You can customise the brightness levels, including the brightness during play, by using the DVD32FLR’s menus. When your DVD32FLR leaves standby the display will be set to the intensity level which is determined in the display menu under ‘startup brightness’. The DVD32FLR allows you to define a different display brightness when a disc is playing (or even to switch off the

Press the open/close(1) button or eject on the remote control and the tray will open.

Put a disc in the tray with its label facing up. Press play(2) to close the tray and start the disc playing.

After a few seconds the disc will start playing.

return		record
skip		LFE
+	pause	+
r	ok	f
e		f
	play
w		d

--- stop ---

skip	LFE	open/close
cancel	eject

display). The display can also be configured to automatically switch to an ‘after hold’ brightness, which can be ‘off’, after a given time interval.

if the TAGtronic Communications Bus is connected

If you have connected the TAGtronic Communications Bus between the DVD32FLR and the TAG McLaren av processor AV32R, and the AV32R(1) is configured to synchronise the DVD32FLR’s front display brightness to the AV32R’s, then your manual setting will be overridden whenever the AV32R changes its front display brightness. The DVD32FLR can also be configured to override the AV32R’s settings. If both products are configured to define the display brightness, then the last change (either from the DVD32FLR or AV32R) will take precedence.

For details see paragraph ‘TAGtronic Communications Bus’ later in this manual and the AV32R user manual.

1.The AV32R needs to run software version v3.6 or higher

If the disc is not loaded correctly, is dirty or faulty, the display will show the message ‘cannot read disc’. If this happens, open the tray and clean the disc.

ATTENTION:

Your DVD32FLR is regionally coded in line with international law. If you try to play a disc of an

incompatible zone the player will refuse to play the disc, showing ‘wrong region’.

1.Should the DVD32FLR be in standby, pressing the open/close key will ‘wake up’ the DVD32FLR and will then automatically, after it carried out its diagnostics, open the tray

2.If the play key is pressed, when the player is in standby, the DVD32FLR will wake up from standby and will, after the initialisation is over, start playing a disc (if one was loaded)