Ultratec 43FDX10B, 43FDX11B, 61UDX10B, 53UDX10B important safety instructions Rear Panel Jacks

REAR PANEL JACKS

a e f

ANT A

TO

CONVERTER

ANT B

AUDIO TO HI-FI

R L

S-VIDEO	S-VIDEO
VIDEO	VIDEO	Y/VIDEO
(MONO)	(MONO)	PB	(MONO)
L	L		L
		PR
R	R		R
AUDIO	AUDIO		AUDIO
INPUT 1	INPUT 2	INPUT 4

		S-VIDEO
Y/VIDEO		VIDEO
PB	(MONO)	L
	L
PR
	R	R
	AUDIO	AUDIO
INPUT 5		MONITOR
		OUT

d b c

aAntenna Input/Output

The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B. ANT A input can be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture. (ANT B cannot be displayed as a sub-picture.) The antenna output labeled ÒTO CONVERTERÓ allows the ANT A connection to pass directly to a different source such as a cable box, only when ANT B is displayed as a main picture.

bAudio/Video Inputs 1, 2, 4 and 5

The VID1~VID5 buttons will select each video source each time it is pressed. Use the audio and video inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (If you have mono sound, insert the audio cable into the left audio jack.)

NOTE: You may use VIDEO or S-VIDEO inputs to connect to INPUT 1 and 2, but only one of these inputs may be used at a time.

cMONITOR OUT

These jacks provide fixed audio and video signals which are used for recording. Use the S-VIDEO Output for high quality video output.

NOTE: S-VIDEO Output may be used for recording, only when the input is of S-VIDEO type.

dAUDIO TO HI-FI Output

These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the stereo can be controlled by the televisionÕs main volume.

eS-VIDEO Inputs 1 and 2

Inputs 1 and 2 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.

11