Ultratec 60FX20B, 50DX20B, 50FX20B Using the Remote to Control DVD Functions

USING THE REMOTE TO CONTROL DVD FUNCTIONS

Operating the precoded function for your DVD Player.

This remote is designed to operate different types of DVD Players. You must first program the remote to match the remote system of your DVD Player. (refer to page 28)

1.Turn ON your DVD Player.

2.Aim the remote control at the front of your DVD Player.

3.Press the DVD/VCR button to switch to the DVD Player pre-coded mode.

4.Hold down the DVD/VCR button on the remote, enter the two digit preset code that matches your DVD Player as shown on page 28. The remote will turn off your DVD Player when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your DVD Player. If the DVD Player does not turn off after five seconds, try a different two digit pre- set code.

5.The remote will now control your DVD Player.

	POWER
TV	CBL/SAT DVD/VCR
PIP	SWAP MOVE
	FREEZE

DVD button

This button allows the remote to control your DVD Player by setting it to DVD mode.

PIP CH

HELPMENU

	SELECT
MUTE	LAST CH
	EXIT

EXCLUSIVE TV buttons

These buttons are for

operating the TV.

VOL CH

1 2 3

4 5 6

7 8 9

INPUT 0 STATUS

PRECODED DVD buttons These buttons always transmit the chosen precoded DVD codes. When the remote is in DVD mode, EXIT button is used as ENTER button.

REC TV/VCR PIX

NOTES:

1.If your DVD Player cannot be operated after performing the above procedures, your DVD Player’s code has not been pre- coded into the remote.

2.In the unlikely event that your DVD Player cannot be operated after performing the above procedures, please consult your DVD Player operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

NOTE: Refer to instruction manual of the DVD Player for operation of the buttons exclusively for the DVD Player.

26