Ultratec 60FX20B HOW to SET UP Your NEW Hitachi Projection TV, Antenna, Location, Viewing

Page 5

HOW TO SET UP YOUR NEW HITACHI PROJECTION TV

ANTENNA

Unless your TV is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient.

LOCATION

Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location selected allows a free flow of air to and from the perforated back cover of the set.

To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can become excessively hot, for example, in direct sunlight or near a heating appliance, etc.

VIEWING

The major benefit of the HITACHI Projection Television is its large viewing screen. To see this large screen at its best, test various locations in the room to find the optimum spot for viewing.

The best picture is seen by sitting directly in front of the TV and about 10 to 18 feet from the screen. Picture brightness decreases as the viewer moves to the left and right of the receiver.

During daylight hours, reflections from outside light may appear on the screen. If so, drapes or screens can be used to reduce the reflection or the TV can be located in a different section of the room.

If the TV’s audio output will be connected to a Hi-Fi system’s external speakers, the best audio performance will be obtained by placing the speakers equidistant from each side of the receiver cabinet and as close as possible to the height of the picture screen center. For best stereo separation, place the external speakers at least four feet from the side of the TV, place the surround speakers to the side or behind the viewing area. Differences in room sizes and acoustical environments will require some experimentation with speaker placement for best performance.

 

 

￿

 

 

￿￿￿￿￿￿￿￿￿￿

 

￿￿￿￿￿

 

 

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿

￿￿

￿￿￿￿￿

￿￿

￿￿￿￿

￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿

￿￿￿ ￿￿￿ ￿￿￿

￿

 

￿￿

 

 

￿￿￿￿￿￿￿￿￿￿

 

 

 

 

￿￿

￿￿

￿￿￿

￿￿￿

￿￿￿

￿

￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿

￿

CAUTION: Magnetic fields, such as those of external speakers, may cause the picture to distort if they are placed too close to the television. Move the magnetic field source away from the television until there is no picture distortion.

5

Image 5
Contents Ultratec BIT-MAP Important Safety Instructions First Time USE Remote ControlON-SCREEN Display Useful Information IndexSafety Points YOU should Know about Your Hitachi Television Important Safety InstructionsPublic Viewing of Copyrighted Material Prevention of Pattern BurnRemote Control AccessoriesAntenna HOW to SET UP Your NEW Hitachi Projection TVLocation ViewingAntenna Connections to Rear Jack Panel HOOK-UP Cables and ConnectorsFront Panel Controls Remote Control sensor Power lightPerfect Picture sensor Digital ArrayRear Panel Jacks Rear Panel Connections Way signal splitterRear Speaker Terminal Connections Connect After Turning the Power of the TV OFFExternal Connections Connecting External Audio AmplifierBefore Operating External Video Source Connecting External Video SourcesConnecting a Monaural Audio VCR or Laserdisc Player Optional, see tips on Connecting a Stereo VCR or Stereo Laserdisc PlayerConnecting a Stereo Laserdisc Player or DVD Player to Input Surround Required Optional Effect Feature Switch Connection Audio System SetupPrecoded VCR/DVD Buttons PICTURE-IN-PICTURE HOW to USE the Remote to Control Your TVStatus button TV Power buttonMENU, SELECT, Cursor buttons Channel Selector buttonsVID3 Input buttonPICTURE-IN-PICTURE PIP button PICTURE-IN-PICTURE PIPCursor buttons Swap buttonMove button Quick Freeze button PICTURE-IN-PICUTRE PIPFreeze button Operating the precoded function for your VCR Using the Remote to Control VCR FunctionsOperating the precoded function for your DVD Player Using the Remote to Control DVD FunctionsOperating the precoded function for your cable/satellite box Using the Remote to Control Cable BOX/SATELLITE FunctionsCABLE, SATELLITE, VCR, and DVD Codes Ultratec OSD Theater Menu Language SET UPReception Band Signal SourceAuto Channel SET Channel Memory Channel List CursorClock SET 11 ~~ Channel ID CustomVideo ID Family Favorites Menu Family Favorites Operation Secret code Parental ControlMovie Ratings Motion Picture Rating ChartTV Ratings TV Parental Guide Rating ChartCanadian Ratings ENG Canadian English Ratings ChartCanadian Ratings FRN Canadian French Ratings Chart+ General Not recommended for young Programming is not suitable for childrenMenu To Menu Bar To Quit I t Event ProgAuto Link Display Closed CaptionMode ChannelVideo ResetContrast Brightness Color Tint SharpnessColor Temperature Advanced SettingsPerfect Picture Auto ColorBass AudioTreble BalanceAuto Noise Cancel MTS ModePerfect Volume Internal SpeakersTheater Modes TheaterDo not Care of Your Hitachi Projection TV Your Remote ControlIgnition Noise Reception ProblemsUseful Info SymptomsInputs SpecificationOutputs 50DX20B 50FX20B 60FX20BHome Electronics Division HitachiDigital Media Division Page Page Page QR47635