Onkyo Connecting the DV-SP501, Basic Setup, Other than European model, North American model

Connecting the DV-SP501—Continued

Basic Setup

The setup described here is a basic setup that allows you to play discs using just the cables supplied with the player. In this setup, stereo audio is played through the speakers in your TV.

VIDEO IN

TV

L

R

ANALOG

INPUT

AUDIO		MONO		Y
		AUDIO
OUTPUT	REMOTE
		OUTPUT
DIGITAL	CONTROL
		ANALOG
OPTICAL COAXIAL
		L		PB
		R	DVD PLAYER	PR
			MODEL NO. DV-SP501

AC INLET

VIDEO OUTPUT

VIDEO

S VIDEO

COMPONENT

•This player is equipped with copy protection technol- ogy. Do not connect this player to your TV via a VCR using AV cables, as the picture from this player will not appear properly on your TV. (This player may also not be compatible with some combination TV/VCRs for the same reason; refer to the manufacturer for more information.)

•If your TV only has a mono audio input, connect it to the DV-SP501’s MONO ANALOG AUDIO OUT- PUT.

Other than European model

•When connecting to your TV as shown above, do not set the “Component Out” setting (page 45) to “Pro- gressive.” (Other than European models.)

1.Connect the VIDEO OUTPUT and AUDIO OUT- PUT ANALOG L/R jacks to a set of A/V inputs on your TV.

Use the supplied audio/video cable, connecting the red and white plugs to the audio outputs and the yel- low plug to the video output. Make sure you match up the left and right audio outputs with their corre- sponding inputs for correct stereo sound.

See the following page if you want to use a compo- nent or S-Video cable for the video connection.

2.Connect the supplied AC power cord to the AC INLET, then plug into a power outlet.

To power outlet

Notes:

•Before unplugging the player from the power outlet, make sure you first switch it into standby using either the front panel STANDBY/ON button, or the remote controller, and wait of the “GOOD BYE” message to disappear from the player’s display.

•For the above reasons, do not plug this player into a switched power supply found on some amplifiers and AV receivers.

Other than North American model and European models

•When TV System is set to “AUTO” or “NTSC”, and playing an NTSC disc only: When “Component Out” (page 45) is set to “Progressive”, there is no video out- put from the “VIDEO OUTPUT” (composite) and “S VIDEO” jacks. If you want to display video on more than one monitor simultaneously, make sure that it is set to Interlace. Switch the player to standby then, using the front panel controls, press STANDBY/ON

while pressing to switch the player back to “Interlace.”

North American model

•When “Component Out” (page 45) is set to “Progres- sive”, there is no video output from the “VIDEO OUTPUT” (composite) and “S VIDEO” jacks. If you want to display video on more than one monitor simul- taneously, make sure that it is set to Interlace. Switch the player to standby then, using the front panel con-

trols, press STANDBY/ON while pressing to switch the player back to “Interlace.”

19