Preparing the Remote Controller
Insert the batteries into the remote controller so you can use it to operate the DVD player.
1 | Open the cover. |
2 | Insert batteries (AA size). |
| Make sure to match the + and – on the |
| batteries to the marks inside the battery |
| compartment. |
|
|
3 | Close the cover. |
Notes on batteries:
Improper use of batteries may cause battery leakage and corrosion. To operate the remote controller correctly, follow the instructions below.
∙Do not insert the batteries into the remote controller in the wrong direction.
∙Do not charge, heat, open, or
∙Do not leave dead or exhausted batteries in the remote controller.
∙Do not use different types of batteries together, or mix old and new batteries.
∙If you do not use the remote controller for a long period of time, remove the batteries to avoid possible damage from battery corrosion.
∙If the remote controller does not function correctly or if the operating range becomes reduced, replace all batteries with new ones.
∙If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new batteries.
∙The batteries should last about one year with normal use.
Operating with the Remote Controller
This section shows you how to use the remote controller.
Point the remote controller at the remote sensor and press the buttons.
30° 30°
Within about 5 m
Distance: About 5
Angle: About 30° in each direction of the front of the remote sensor
*Do not expose the remote sensor of the DVD player to a strong light source such as direct sunlight or illumination. If you do so, you may not be able to operate the DVD player with the remote controller.
Notes on the remote controller:
∙Direct the remote controller at the remote sensor of the DVD player.
∙Do not drop or give the remote controller a shock.
∙Do not leave the remote controller near an extremely hot or humid place.
∙Do not spill water or put anything wet on the remote controller.
∙Do not open the remote controller.
Connections Introduction
11