Onkyo DV-S717 instruction manual Connecting to an Amplifier Equipped With a DTS Decoder

Warning

• Do not set “Audio Out Select to “Bitstream” from the menu 32 38 unless you are connecting (via the DIGITAL OUTPUT jack) an AV decoder that has the Dolby Digital or Digital Theater System (DTS) decoding function. High volume sound may damage your hearing as well as the speakers.

•When playing DTS-encoded discs (DVD videodisc and audio CDs), excessive noise may be exhibited from the analog stereo jacks. To avoid possible damage to the audio system, you should take proper precautions when the ANALOG OUTPUT jacks of the DVD player is connected to an amplification system. To enjoy DTS Digital Surround™ playback, an external 5.1 channel DTS Digital Surround™ decoder system must be connected to the DIGITAL OUTPUT jack of the DVD player.

Connecting to an Amplifier Equipped With a DTS Decoder

Introduction

ANALOG DIGITAL

OUTPUT OUTPUT REMOTE CONTROL

Digital Theater Systems (DTS)

DTS is a high quality surround technology used in theaters and now available for home use, on DVD video discs or audio CDs.

VIDEO OUT

L

COAXIAL OPTICAL

If you have a DTS decoder or processor, you can obtain the full

Y CB CR S VIDEO VIDEO

Signal flow

R

75 Ω coaxial cable

Optical digital cable

benefit or 5.1 channel DTS encoded sound tracks on DVD video discs or audio CDs.

• Use DVD video discs or audio CDs encoded via the

Connections

Connection	To COAXIAL type	To OPTICAL type digital audio
example	digital audio input	input

Amplifier equipped with a

DTS decoder

DTS recording system.

• Make the following setting

Setting	Select:	Page
Audio Out Select	Bitstream	38

Front speaker (left)

Center speaker

Rear speaker (left surround)

	Front
TV	speaker
	(right)

Sub woofer

Rear speaker

(right surround)

Recording system DTS 29

Connecting to an Amplifier Equipped With a Digital Audio Input

			ANALOG	DIGITAL	REMOTE
			OUTPUT	OUTPUT
					CONTROL
	VIDEO OUT		L	COAXIAL OPTICAL
			R
Y	CB CR	S VIDEO	VIDEO

	75 Ω
Signal flow	coaxial
	cable

			Optical digital cable
Connection To COAXIAL type			To OPTICAL type digital audio
example	digital audio input		input
			Amplifier equipped with a
			Digital Audio Input
	Front		Front
	speaker		speaker
	(left)	TV	(right)

2 Channel Digital Stereo

You can enjoy the dynamic sound of 2 Channel Digital Stereo by connecting an amplifier equipped with a digital audio input and speaker system (right and left front speakers).

• Make the following setting

Setting	Select:	Page
Audio Out Select	PCM	38

Notes:

∙DO NOT connect the DIGITAL OUTPUT jack of the DVD player to the AC-3 RF input of a Dolby Digital Receiver. This input on you’re A/V Receiver is reserved for Laserdisc use only and is incompatible with the DIGITAL OUTPUT jack of the DVD player.

∙Connect the DIGITAL OUTPUT jack of the DVD player to the “DIGITAL” or “COAXIAL” input of a Receiver or Processor.

∙Refer to the Instruction manual of the connected equipment as well.

∙When you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections.

∙The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.

∙ Turn off the amplifier before you connect or disconnect the DVD player’s power cord. If you leave the amplifier power on, the speakers may be damaged. 15