Muse electronic Model Eleven manual Setup Menu, Initial Settings

Setup Menu

If your Model Eleven will be used only to play standard CDs no setup will be required. If, however, you intend to play any of the higher performance formats such as DVD-V, DVD-A or SACD, you will need to configure the Model Eleven for your system. In order to setup the Model Eleven a video device will be required to view the various menus. Once configured, a video device is not required for day-to-day operation, though a video device may be helpful.

To enter the setup menu, press the “Shift” button located on the lower left corner of the multi- function remote. This will cause a blue LED to illuminate on the front panel of the Model Eleven. This LED indicates that all commands will follow the blue labels on the multi-function remote.

To access a red command, press the “Release” button on the multi-function remote; this will cause the front panel LED to extinguish and the Model Eleven will now execute the commands in red.

With the blue shift LED on the front panel illuminated, press the “Standby” button, which is located in the upper left corner of the multi- function remote. This will cause the Model Eleven to wake up and enter its operational state and will extinguish the shift LED on the front panel.

To access the setup menu, make certain that your video device is on and set to the proper input to view the Model Eleven (see cabling requirements under the section titled “Setup”). Press the “Shift” button on the remote (blue LED illuminates) followed by the “Action” button on the remote. You will now see a menu of six different groups of settings for the Model Eleven. The upper left group titled “Audio Settings” will be highlighted. Any of the six submenus can be selected by navigating around the display using the four remote control navigation buttons. These buttons are labeled “Up”, “Down”, “Left” & “Right” and are labeled in red. Since all four of these buttons are labeled red, you must make certain that the Model Eleven is not in shift

mode. Looking at the front panel and determining if the blue shift LED is illuminated can confirm this. Since your last command was “Action” which is labeled in blue, you will need to

deactivate the shift mode. This is accomplished by pressing “Release” on the multi-function remote and verifying that the blue shift LED has been extinguished. Now is a good time to practice navigating the on screen menu choices using the four remote buttons.

When you are finished, select the block titled “Initial Settings” by first navigating to and activating this button by pressing the “Select” button (located in the middle of the four navigation buttons).

Initial Settings

A submenu titled “Initial Settings” will appear on the video device. This page contains a column of settings on the left side of the screen and a list of sub-submenu and corresponding choices on the right side of the screen.

4