To Reconnect the Device and the Receiver

Targus Voice Recording presenter with Laser Pointer

1.Position the Power Switch to “Presenter” mode to turn on the presenter. This presenter is a plug and play device and should work once the USB receiver is connected to and recognised by the computer. If the device is not working or you have recently replaced the batteries, you can try to reset the ID code between the receiver and the remote. To do this, do the following:

2.Once the computer has recognised the device. Press the connection button on the receiver.

3.After the connection button is pressed on the receiver, press the

connection button on the back side of the presenter. The devices are paired and ready to use.

Using the Presenter as a SD memory card reader

(Type-A) USB tip

(Type-B) USB tip USB data transfer cable

1.Position the Power switch to “Card Reader / Off” position.

2.Connect the presenter with the computer using the USB data transfer cable provided. Please make sure the mini USB connector (Type-B) is connected to the presenter’s USB port and the large USB connector (Type-A) is connected to the computer’s USB port.

3.Insert the SD memory card into the presenter’s card slot until it is fully inserted.

The computer will detect the memory card and once detected, the memory card is ready for access.

Note: Please remember to turn the power off (to Card Reader / Off mode) before connecting the data cable to the PC for card reader function. For best performance please use SD card with minimum of 128MB storage space. Try to avoid using mini SD card with adapter. Avoid having a large amount of data stored in the SD card. It will delay the loading time for the presenter.